Balance Shaft Removal Kit   This kit is designed to eliminate the balance shafts in a 3RZ or 2TR engine. Kit includes new bearings, replacement inserts, billet aluminum install driver, oil squirter to keep the chain properly lubricated, drill bit,...

Short Shifter Kit 1986-1987 R151 Turbo Transmission You MUST measure your transmission for fitment. NO RETURNS ACCEPTED ON ANY SHORT SHIFTER KIT Fitments listed are suggestive. We cannot quote direct fitment to any vehicle, as Toyota changed too much,...

Valve Cover Gasket Set These valve cover gaskets feature precision edge-molded silicone rubber, which resists high heat and delivers reliable sealing on irregular surfaces. This silicone rubber is wrapped around a rigid carrier that adds strength to...

Lower Ball Joint (Passenger Side) When it comes to ball joints, there are a lot of options out there, but there is only one that performs better and lasts longer than the rest, OE replacement. This is the same ball joint Toyota used on Tacomas back in...

Lower Ball Joint (Driver Side) When it comes to ball joints, there are a lot of options out there, but there is only one that performs better and lasts longer than the rest, OE replacement. This is the same ball joint Toyota used on Tacomas back in the...

Oil Pick Up Tube 3.4L V6 (5VZ-FE) (Rear Sump Oil Pan) If you're rebuilding your motor and plan on using the factory pan. It's a good idea to replace the pickup for cheap insurance. Over time, the factory oil pickup tube can accumulate debris that you...

LCE Differential Breather Kit A differential / axle breather serves the important purpose on a 4WD vehicle of venting the air pressure in drivetrain assemblies such as the differentials, transmission and transfer case. Under normal operations, these...

ULTIMATE Lift Hood Strut Kit (96-02 4Runner) Our new ULTIMATE Lift Hood Strut Kit for 3rd Gen (’96-’02) 4Runners eliminates the prop rod and makes your engine compartment free and clear of obstacles. One-handed hood opening and closing...

ULTIMATE Lift Hood Strut Kit (95-00 Tacoma) Our new ULTIMATE Lift Hood Strut Kit for early 1st Gen (’95-’00) Tacomas eliminates the prop rod and makes your engine compartment free and clear of obstacles. One-handed hood opening and closing...

Wear Pad & Hardware Kit (LC Engineering Aluminum Flywheel Only) LC Engineering friction plates are made of high quality 1045 high carbon steel to withstand high heat under extreme friction. CAD/CAM designed and then CNC machined to strict...

Hall Sensor Mount When installing our LC Pro Fuel Injection System on a 5VZ (3.4 V6), this bracket mounts the Hall Effect Sensor perfectly to generate a signal from the crank pulley. Contact our Tech Support Line for further information at...

Toytec Rear Add-A-Leafs Offering OEM Style anti-friction Pads, these are a long rear add-a-leaf for the best ride. This kit includes New Leaf Spring Center Pins. NOTE: If your 87-95 Pickup or 86-89 4Runner has 3.25" ID rear U-bolts, this kit will not...