1997

Allen Head Hardware Kit (Oil Pump Cover) On your 2RZ/3RZ engine, replacing the hardware is recommended every time you remove your oil pump cover, Phillip's screws get worn out, and the heads are easily stripped if you don't use an impact screwdriver...

Oil Feed Fitting Kit LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. Kit Includes: (1) 12mm Banjo Bolt (1) - 4 AN Banjo Fitting (2) 12mm Copper Crush Washers Contact our...

GT25 Turbo Discharge Gasket (5 Bolt) Stainless Steel GT25 Discharge Gasket. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174. Check out ...

OEM Shifter Boot (Manual Transmission) It's common for the factory shift lever boot to degrade over time, crumble and disintegrate. This often results in dirt and mud getting into the transmission shifter then into the transmission. This simple rubber...

K&N Air Filter Oil (99-0516) K&N 99-0516 is a 12.25 ounce aerosol can of air filter oil. K&N Air Filter Oil is the only oil specially formulated to work in combination with the cotton fabric in K&N air filter elements providing a superior air...

K&N Air Filter Oil (99-0504) K&N 99-0504 is a 6.5 ounce aerosol can of air filter oil. K&N Air Filter Oil is the only oil specially formulated to work in combination with the cotton fabric in K&N air filter elements providing a superior air filtration...

Steel Weld-On Flange (Inlet / Outlet) If you are plumbing your wastegate into the exhaust pipe, these fitting are a good starting point. These Turbosmart wastegate flanges make installing your wastegate easy. These flanges are made out of the best...

ARP Heavy Duty Steering Knuckle Stud Magnum knuckle studs are stronger than any other stock replacement Toyota knuckle stud on the market. These heavy-duty studs are manufactured by world-renowned bolt manufacturer ARP (Automotive Race Products). Each...

1 3/4" Radiator Cap (Small) This Sankei OEM style Japan Radiator Pressure Cap that directly replaces the factory caps. The cap is 100% Stainless Steel and is a 13 pound cap or 0.9 kg/cm. Toyota used two styles of radiator caps the small one that...

Turbo Oil Drain Plate (w/ 1/2" NPT Boss For Block Side) Provides a 1/2" NPT port for a custom oil drain fitting. Eliminates the need to use the hard-to-find factory thread fitting that comes from the factory. Contact our Tech Support Line for...

Silicone Adapter (2.5" to 3") Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

Oil Filter Housing Seal Kit (OEM) When removing the oil filter housing, it is always a good idea to replace these two O-ring seals. Any leak in this area can contaminate the system and affect oil pressure, not to mention the mess in the engine...