Pro Comp 3" Leveling Kit Pro Comp is the fastest, safest, least expensive way to bring the front of your vehicle level with the rear. This gives you the clearance and ability to add wheels and tires up to 33" in diameter. Pro Comp products do not...

Catalytic Converter (Rear) MagnaFlow Direct-Fit Catalytic Converters are designed for easy bolt-on installation for the Professional Installer. Each is designed to exact original equipment specifications. This setup will have an overall length of 31"...

Rod Bearing Set (0.50mm / +.020") These bearings for the 2RZ and 3RZ engines are factory replacement bearings. These factory replacement bearings offer the reliability and durability that you expect from LC Engineering. Contact our Tech Support...

DJM Complete Lowering Kit (3" Front & 3" Rear) A complete one box lowering kit for your Tacoma. 3″ in the front by repositioning your lower ball joint and then using new upper control arms to set your alignment back to factory specs and 3″ in the...

DJM Complete Lowering Kit (3" Front & 4" Rear) A complete one box lowering kit for your Tacoma. 3″ in the front by repositioning your lower ball joint and then using new upper control arms to set your alignment back to factory specs and 4″ in the rear...

OEM Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. The bolt size is m16 x 1.50. It is recommended to use...

Oil Filter Housing Seal Kit (OEM) When removing the oil filter housing, it is always a good idea to replace these two O-ring seals. Any leak in this area can contaminate the system and affect oil pressure, not to mention the mess in the engine...

Cross Drilled Slotted Rotors A moving vehicle has a large amount of kinetic energy, and the brakes have to remove this energy in order to stop. How do the brakes do this? Each time you stop, your brakes convert the kinetic energy to heat generated by...

Hand Held LCD Controller Lost the controller for your LC Pro Fuel System? Don't worry, we now offer the hand-held LCD programmer by itself. This unit plugs into the ECU via a six foot cable. This also takes the place of the laptop used on most other...

Garrett GT2554R (Low Boost) Garrett's ball bearing cartridge has proven its worth in the highest level of motorsports where it has been the bearing system of choice in CART FEDEX ChampCar Series, 24 Hours of Le Mans, Pikes Peak International Hill...

Magnuson Supercharger Oil Service Kit (Black Body) Magnuson Superchargers have their own sealed oil reservoir that doesn't use the engine's oil so it makes them very low maintenance. Magnuson recommends the oil be checked by 60k Miles and changed by...

Serial Cable Serial Cable to connect your computer to split second box or, SDS computer to SDS controller. Length: 10ft / 3m Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration...