K&N Filter Care Service Kit (Aerosol / 99-5000) K&N Recharger Kit 99-5000 is designed to service your K&N oiled cotton air filter when it gets dirty. The kit comes with K&N Power Kleen air filter cleaner and K&N air filter oil. The 99-5000 Recharger...

K&N Sealing Grease (99-0704) K&N Sealing Grease 99-0704 provides an airtight fit around sealing surfaces on all types of air filter elements. It resists heat and will not melt or run off. K&N Sealing Grease is designed to ensure the filter stays sealed...

Intake Valve Seat (20+ Lbs of Boost) 40mm Pro Valve Seats are made of Nickel Aluminum Bronze material for extra long life in performance engines. With track proven results the machine-ability, longevity, and thermal conductivity far surpass the stock...

Spring Seat Shim Set (Single Spring / .025″) Hardened Valve Spring Shims for 2RZ and 3RZ with Single Street Performer Valve Springs. NOTE: Sold as a set of (16). Contact our Tech Support Line for further information at 928-575-2174...

Fuel Pressure Gauge (1.5" Diameter / 0-60 Psi) These fuel pressure gauges are for EFI engines that run low fuel pressures. They are compact and accurate, using a 1 1/2 in. diameter durable, rust-free, stainless steel bezel and case and a crisp,...

Front Sway Bar Bushings (26mm) Improved handling, low cost, and easy installation are just some of the reasons these components are so popular! These sway bar bushings offer the greatest improvement in performance handling on trucks and sport utility...

Front Sway Bar Bushings (27mm) Improved handling, low cost, and easy installation are just some of the reasons these components are so popular! These sway bar bushings offer the greatest improvement in performance handling on trucks and sport utility...

Fuel Filter When was the last time you changed your fuel filter? Toyota recommends changing it out every 30,000 miles, but some prefer changing theirs every 15,000 for many reasons. LC Engineering carries fuel filters for your Toyota. One of the most...

Rear Main Seal OEM replacement rear main seal. This will install on the big end of the crankshaft. If there is a large groove on the crank seal surface be sure to get our seal saver for trouble-free installation. For the Seal Saver, see Part #:...

Thermostat (180 Degree) Reduced engine temperatures add life to your engine and provide a denser air/fuel mixture which helps produce more horsepower. Consistent control of the engine temperature allows an engine to operate at its peak efficiency, no...

Exhaust Valve Seat (20+ Lbs of Boost) 33mm Pro Valve Seats are made of Nickel Aluminum Bronze material for extra-long life in performance engines. With track proven results the machine-ability, longevity, and thermal conductivity far surpass the stock...

Street Rod Bushing Set (4) Any time you remove your connecting rods it is a good idea to change out the piston pin bushings. After a while, the bushings will wear out causing the piston to "walk" in the bore and could eventually cause major engine...