Pressure Plate Bolt Pressure plate bolts play an important role in the performance and safety of race cars and street machines alike. That's why LC Engineering recommends replacing yours whenever you change your pressure plate. OEM Toyota Part #:...

Weld-On Oxygen Sensor Flange (2-Bolt Flange Style) This flange is made from 3/8" mild steel, then tapped for M8 x 1.25 studs weld on. For the 2 bolt style O2 sensor. NOT for thread-in O2 sensors. Contact our Tech Support Line for further...

Intake Manifold Stud Kit This kit comes with all new studs to mount your manifold to your cylinder head. Replacing your stock intake bolts with studs will allow you to remove and reinstall your manifold numerous times without having to worry about...

Plug Wire Separator Kit Pro Wires (8.5mm) - Black These composite separators are held together with allen head screws which are mounted flush within the loom. These separators are designed specifically to work with our billet wire loom and LC Pro Wires...

Rubber Tailpipe Hanger (2-Hole) Factory replacement rubber insulator for tailpipe. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the...

T3 Turbo Discharge Gasket (5 Bolt) Stainless Steel T3/T4 Discharge Gasket. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the product listed...

1/4" 90 Degree Fitting (Push-Lok to -4AN Swivel) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This 90 degree fitting is used for the oil feed line at the turbo or block. Perfect for...

2" Silicone Coupler Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following temperature range:...

Plug Wire Separator Kit (8.5mm Pro Wires) These composite separators are held together with Allen head screws which are mounted flush within the loom. These separators are designed specifically to work with our billet wire loom and LC Pro Wires. They...

Intake Manifold Gasket (Plenum) LC Engineering offers the best quality gaskets possible for your Toyota engine. Over time, the factory gaskets become brittle and break. Replace a leaky or corroded gasket before severe damage occurs! This gasket is the...

Brake Caliper Hard Line (Left Side) This is the OEM hard line that goes from the caliper to the spindle. Tundra 2000-2006 / Sequoia 2002-2007 OEM Toyota Part #: 47318-0C020 Contact our Tech Support Line for further information at 928-575-2174...

Brake Caliper Hard Line (Right Side) This is the OEM hard line that goes from the caliper to the spindle. Tundra 2000-2006 / Sequoia 2002-2007 OEM Toyota Part #: 47315-0C020 Contact our Tech Support Line for further information at 928-575-2174...