OEM Exhaust Manifold Stud When installing new aftermarket headers, new hardware should be used. An even clamping force is required to keep the header tight against the head in order to seal the exhaust gasket properly. The studs on your truck may be 20...

Denso Iridium IK22 Spark Plug These 2 step colder plugs are recommended by URD if you are running the 7th Injector upgrade on a Supercharged 5VZ engine. If you are running the stock pulley (Low Boost) on the 5vz supercharger, Magnuson recommends...

Flexplate Bolt (OEM) Connect that flexplate with confidence. This OEM flexplate bolt is just what the doctor ordered to replace your flexplate bolt that you lost or misplaced. They have a black oxide finish to help resist rust and corrosion...

PCV Valve (OEM) This is a factory replacement PCV valve. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact...

Hardware Kit (Exhaust Flange) Exhaust hardware kit used on the two-bolt collectors in the header and exhaust kits. Kit Includes: (4) Mechanical locking nuts (M10 x 1.25mm) (4) Flange Bolts (M10 x 1.25mm x 40mm grade 10.9) NOTE: All hardware is...

O-Ring (Oil Pump) The oil pump O-ring seals and mates the surfaces to keep oil in its respective place. Over time O-rings become brittle and break. Replace a leaky or corroded O-rings before severe damage occurs. OEM Toyota Part #:...

T3 Turbo Inlet Gasket LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This stainless steel gasket has a crush ring to provide a perfect seal even if there are slight imperfections in...

45° Oil Drain Fitting (1/2" NPT Male to -8AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil drain at the turbo or oil pan. Perfect for going...

Nylon Shift Lever Bushing (End of the Handle) If your shifter on your manual transmission is loose and sloppy, this bushing is in need of replacement. This is an OEM nylon cup that fits over the ball end of the shift lever (transmission side). We...

Spring Seat / Shim (Dual Springs) The LC Engineering 5VZ/1GR Pro Dual Valve Spring Seats are designed to be used with the Pro Dual Valve Springs. NOTE: Sold individually. This product should not be used in a manner that violates Federal EPA Laws...

Fuel Injector Top Grommets This is a new set of fuel injector grommets that go on the top of the fuel injector. Stop pesky fuel leaks at the fuel rail by replacing these grommets. NOTE: Sold as a set of (4). Contact our Tech Support Line for...

Round Collector Exhaust Gasket Set This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. In the stock application, two will be required, this is a kit and will include (2) gaskets. Alternate exhaust...