2006

Hardware Kit (Exhaust Flange) Exhaust hardware kit used on the two-bolt collectors in the header and exhaust kits. Kit Includes: (4) Mechanical locking nuts (M10 x 1.25mm) (4) Flange Bolts (M10 x 1.25mm x 40mm grade 10.9) NOTE: All hardware is...

T3 Turbo Inlet Gasket LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This stainless steel gasket has a crush ring to provide a perfect seal even if there are slight imperfections in...

45° Oil Drain Fitting (1/2" NPT Male to -8AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil drain at the turbo or oil pan. Perfect for going...

Round Collector Exhaust Gasket Set This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. In the stock application, two will be required, this is a kit and will include (2) gaskets. Alternate exhaust...

Toytec Replacement Center Pins (Pair) (2) Replacement center pins for rear Add-A-Leafs. These are included in all of our lift kits with add-a-leafs. NOTE: Due to many supply chain issues, this product may be on backorder and could take from a few...

T-Bolt Hose Clamp (You Choose Size) Our T-Bolt clamps are all 100% Stainless Steel to stand up to all weather conditions to protect against corrosion. Each clamp has rounded smooth band edges to prevent cutting into you silicone hoses. Engineered and...

Pilot Bearing The crankshaft pilot bearing does not require routine maintenance, but should be replaced when clutch replacement becomes necessary. In some cases, pilot bearings can wear excessively when mounting bolts loosen. Contact our Tech...

Round Collector Exhaust Gasket (2-Bolt x 2 1/2" Flange) If you plan to connect your header to the rest of your exhaust, you will need a collector gasket. OEM gaskets feature a carbon material and stainless steel fire ring for a long life and a positive...

Round Collector Exhaust Gasket (2-Bolt x 2 1/4" Flange) If you plan to connect your header to the rest of your exhaust, you will need a collector gasket. OEM gaskets feature a carbon material and stainless steel fire ring for a long life and a positive...

1/4" Blue High Pressure Hose (Fuel or Oil / Teflon Lined / Push-Lok Compatible) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This 1/4" hose is perfect as an oil feed for your...

Air Injection Gasket LC Engineering only uses factory Toyota exhaust gaskets on the 2TR Exhaust or our Street Header. This ensures that you get the best seal on your exhaust with no chance of burning out cheap aftermarkets gaskets. OEM Toyota Part #:...

Exhaust Clamp (2 1/4") This 2-1/4" exhaust clamp allows you to attach your exhaust without welding. This makes the future removal of your exhaust system much easier. These are the clamps used on LC Engineering's Performance Exhaust Systems. It can be...