Water Pump Gasket (OEM) Gaskets seal and mate surfaces between various components to keep oil, coolant, air, and fuel in their respective places. Over time gaskets become brittle and break. Replace a leaky or corroded gasket before severe damage occurs...

Fuel Pressure Gauge "T" Fitting (5/16" Hose to 1/8" NPT) This fitting makes installing your fuel pressure gauge much easier. The fitting has an 1/8"npt "T" fitting along with two 5/16" hose barbs. This will allow you to install your fuel pressure...

Oil Drain Fitting (Weld On -10AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This Steel fitting gets welded to the oil pan for the oil drain from the turbo. Contact our...

45° Oil Drain Fitting (1/2" NPT Male to -10AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil drain at the turbo or oil pan. Perfect for going...

Weld On Bung & Plug Kit (Thread-In Bosch Style) If you are installing an oxygen sensor in a system that didn't originally come with one, or if you are installing a stand-alone Wideband AFR gauge, you will need this kit. It comes with the bung (18mm...

Heavy Duty Shifter Seat (Blue) It's common for the factory shift lever ball seat to wear, crumble and disintegrate over time. This often results in a sloppy or loose t-case shifter. The factory seat is soft so it can be squeezed into position. These...

Heavy Duty Shifter Seat (White) It's common for the factory shift lever ball seat to wear, crumble and disintegrate over time. This often results in a sloppy or loose transmission shifter. The factory seat is soft so it can be squeezed into position...

Street Rod Bushing Set (Standard) Any time you remove your connecting rods it is a good idea to change out the piston pin bushings. After a while, the bushings will wear out causing the piston to "walk" in the bore and could eventually cause major...

Oxygen Sensor Install Kit (2-Bolt Style) This kit contains everything you need to install the factory 2-bolt O2 sensor into your custom exhaust. It allows you to weld in the O2 sensor wherever you want it in the exhaust. Kit Includes: (2) Studs and...

2-Bolt Flange (2 1/4") Steel flange designed for connecting to our header collectors. This is perfect if you are fabricating your own exhaust from the header back. 3/8" thick, for 2-1/4" exhaust tubing. Contact our Tech Support Line for further...

Rubber Tailpipe Hanger (3-Hole) Factory 3 Hole replacement rubber insulator for tailpipe. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent...

2-Bolt Wastegate Flange (You Choose Style) All of LC Engineering's flanges are laser cut then finished machined on the CNC to ensure exact tolerances and fit. These 2-bolt flanges fit most 38mm wastegates such as Tial, Turbosmart, and Turbonetics. They...