Pressure Plate Bolts (Set of 6) Pressure plate bolts play an important role in the performance and safety of race cars and street machines alike. That's why LC Engineering recommends replacing yours whenever you change your pressure plate. OEM Toyota...

Rubber Tailpipe Hanger (2-Hole) Factory replacement rubber insulator for tailpipe. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the...

T3 Turbo Discharge Gasket (5 Bolt) Stainless Steel T3/T4 Discharge Gasket. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the product listed...

1/4" 90 Degree Fitting (Push-Lok to -4AN Swivel) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This 90 degree fitting is used for the oil feed line at the turbo or block. Perfect for...

2" Silicone Coupler Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following temperature range:...

Flexplate Bolt (OEM) Connect that flexplate with confidence. This OEM flexplate bolt is just what the doctor ordered to replace your flexplate bolt that you lost or misplaced. They have a black oxide finish to help resist rust and corrosion...

Hardware Kit (Exhaust Flange) Exhaust hardware kit used on the two-bolt collectors in the header and exhaust kits. Kit Includes: (4) Mechanical locking nuts (M10 x 1.25mm) (4) Flange Bolts (M10 x 1.25mm x 40mm grade 10.9) NOTE: All hardware is...

T3 Turbo Inlet Gasket LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This stainless steel gasket has a crush ring to provide a perfect seal even if there are slight imperfections in...

45° Oil Drain Fitting (1/2" NPT Male to -8AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil drain at the turbo or oil pan. Perfect for going...

Round Collector Exhaust Gasket Set This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. In the stock application, two will be required, this is a kit and will include (2) gaskets. Alternate exhaust...

T-Bolt Hose Clamp (You Choose Size) Our T-Bolt clamps are all 100% Stainless Steel to stand up to all weather conditions to protect against corrosion. Each clamp has rounded smooth band edges to prevent cutting into you silicone hoses. Engineered and...

Pilot Bearing The crankshaft pilot bearing does not require routine maintenance, but should be replaced when clutch replacement becomes necessary. In some cases, pilot bearings can wear excessively when mounting bolts loosen. Contact our Tech...