Flywheel Bolt Kit (OEM) Connect that flywheel with confidence. These OEM flywheel bolts are just what the doctor ordered to connect your flywheel to your engine. They have a black oxide finish to help resist rust and corrosion. OEM Toyota Part #:...

Zinc Slotted Rear Axle Shims (95.5+ Tacoma trucks) These shims have been used by our dealers and installers to eliminate rear driveline vibrations on 95.5+ Tacoma trucks. Please choose degree of shim above. Kit Includes: (2) Slotted Axle Degree...

Exhaust Valve (Street / Stock Size) These stainless steel valves are given a special anti-friction coating to promote better airflow and minimize resistance in the valve guide. High performance (21-4N) high-grade steel with a Black Nitride coating for...

Intake Valve (Street / Stock Size) These stainless steel valves are given a special anti-friction coating to promote better airflow and minimize resistance in the valve guide. High performance (21-4N) high-grade steel with a Black Nitride coating for...

+1MM Intake Valve (Nitride / 38.50MM) These valves are 1MM larger than stock, great for ported street heads that don't need the huge oversized valves. The black nitride valves are stainless steel valves with a multi-stage heat treatment and stress...

Viton Valve Seals Viton Valve Seals are the latest in valve seal material, surpassing Teflon! Heat resistant to 440 degrees, they eliminate oil consumption through the valve guide and provide smoother engine idling by stopping manifold air and oil...

Balance Shaft Bearing Remove & Install Tool This is a custom designed tool (machined from billet aluminum) for removing and installing balance shaft bearings in 3RZ and 2TR engines. Contact our Tech Support Line for further information at...

OEM Exhaust Hardware Kit This kit will contain (2) Bolts and (2) Springs needed for installing your exhaust back on at the collector. Kit Includes: (2) 90080-10291 Bolts (2) 90501-A0031 Springs Contact our Tech Support Line for further...

Header Stud Set The factory exhaust manifold studs have a shoulder in the center that can interfere with proper header tightening. Our 10mm x 48mm long, heat treated and plated header mounting studs are stronger than stock. Kit Includes: (8)...

Safety Auto Thrust Bearing Set (Standard) When overhauling/rebuilding an engine, it is highly recommended that you replace all bearings in the bottom end. These bearing sets will get your engine back to the proper specification and ready for the miles...

Water Pump Gasket (OEM) Gaskets seal and mate surfaces between various components to keep oil, coolant, air, and fuel in their respective places. Over time gaskets become brittle and break. Replace a leaky or corroded gasket before severe damage occurs...

Street Rod Bushing Set (Standard) Any time you remove your connecting rods it is a good idea to change out the piston pin bushings. After a while, the bushings will wear out causing the piston to "walk" in the bore and could eventually cause major...