OEM Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. The bolt size is m16 x 1.50. It is recommended to use...

Oil Filter Housing Seal Kit (OEM) When removing the oil filter housing, it is always a good idea to replace these two O-ring seals. Any leak in this area can contaminate the system and affect oil pressure, not to mention the mess in the engine...

OEM Heater Tube (Under EFI Manifold) This is OEM toyota part and should be replaced if yours is corroded. OEM Toyota Part #: 87208-35170 NOTE: Should be used w/ our Part #: 1060012. Contact our Tech Support Line for further information at...

Breather Hose (Front Of Valve Cover) OEM Toyota hose comes off the valve cover and goes to intake manifold. OEM Toyota Part #: 12262-35040 NOTE: Not for EFI applications. For EFI applications, see Part #: 1072415 (1984-1988), or Part #: 1072411...

Safety Auto Rod Bearing Set (.25mm / +.010″) When overhauling/rebuilding an engine, it is highly recommended that you replace all bearings in the bottom end. These bearing sets will get your engine back to the proper specification, and ready for the...

CT-20 Turbo Stud Kit This stud kit was made to attach the CT-20 Turbo to the stock turbo manifold on your Toyota 22R-TE. If you find yourself needing to take apart a 20+ year old turbo setup, it is likely your old studs will be damaged or worn out. Why...

Cross Drilled Slotted Rotors A moving vehicle has a large amount of kinetic energy, and the brakes have to remove this energy in order to stop. How do the brakes do this? Each time you stop, your brakes convert the kinetic energy to heat generated by...

Throttle Position Sensor Plug (w/ Wires) As time marches on Toyota will, little by little, discontinue parts it carries for the 22R/22RE powered trucks. We are here working hard to step in and make sure that the parts you need are still out there to...

Header Stud Set Replacing your Turbo manifold? It is a good idea to replace your studs too! LC Engineering offers nothing but the best quality components around. The factory exhaust manifold studs have a shoulder in the center that can interfere with...

OEM EGR Crossover Gasket OEM Gasket for that EGR Crossover plate located on the back side of the cylinder head. OEM Toyota Part #: 11182-35050 Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Hand Held LCD Controller Lost the controller for your LC Pro Fuel System? Don't worry, we now offer the hand-held LCD programmer by itself. This unit plugs into the ECU via a six foot cable. This also takes the place of the laptop used on most other...

Holley Fuel Pressure Regulator Gauge Kit (1-4 PSi / Carb Only) If you are running a Weber carburetor on your Toyota truck, this kit is a must-have and a great way to keep your fuel system running right. Weber carbs work best in the 2.5-3psi range...