Year

Timing Cover Gasket (Passenger Side) Driver's side timing cover gasket fits all years 3RZ. OEM factory replacement gasket for a long life. OEM Toyota Part #: 11328-75021 Contact our Tech Support Line for further information at 928-575-2174...

OEM Flywheel Bolt Kit Connect that flywheel with confidence. These OEM flywheel bolts are just what the doctor ordered to connect your flywheel to your engine. They have a black oxide finish to help resist rust and corrosion. OEM Part #: 90105-10294...

T3 Turbo Discharge Gasket (4 Bolt) Stainless Steel T3 Discharge Gasket. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174. Check out ...

Street Distributor Cap (Clip Style) This is a OE style replacement distributor cap for the older clip style distributors.The cap is the smaller 3" cap vs the larger late model screw down caps that are 3 1/2". A must when changing spark plug wires...

Valve Keepers It is recommended to use hardened valve keepers every time you re-build your engine. LC Engineering carries hardened valve keepers for all 3VZ valves using stock Toyota retainers or Street Performer retainers. A must for any high RPM...

Front Coil Spring Isolator Bushing Made of superior HYPER-FLEX polyurethane material. Saves replacing again & again, lasting from 3 to 10 times longer than rubber isolators. Assemble to the chassis the same way as O.E.M. isolators. They do not...

K&N Filter Care Service Kit (Squeeze Red / 99-5050) K&N Recharger Kit 99-5050 is designed for cleaning your K&N oiled cotton air filter when it is time to be serviced. The kit comes with K&N Power Kleen air filter cleaner and K&N air filter oil...

K&N Power Kleen Filter Cleaner (99-0621) K&N part 99-0621 is a 32 ounce pump spray bottle of Power Kleen Air Filter Cleaner. K&N Power Kleen is the only cleaner recommended to clean K&N cotton air filter elements. K&N 99-0621 Air Filter Cleaner will...

22RE Cold Start Injector Block Plate Kit (22RE EFI Intake Manifold) This kit is designed to allow you to safely block of the cold start injector and supply when you are upgrading your efi system to a stand alone fuel management. NOTE: For a complete...

Turbo Wristpin LC Engineering can supply replacement wrist pins and locks for our forged pistons. Wristpins are available in either standard thickness (.120") or "Turbo" version (.155"). These pins are designed to fit our forged pistons only and are...

Intake Manifold Stud Kit This kit comes with all new studs to mount your EFI manifold to your cylinder head. This kit also comes with a new long allen bolt to replace to old bolt that goes through the thermostat housing to the head. Replacing your...

Idle Speed Adjusting Screw (w/ O-Ring) Is your Idle Speed Screw loosening by itself keeping the motor from idling properly? Is it stripped out from all of the adjustments over the years? Is it even on the throttle body anymore or did it fall out? LC...