Year

Oxygen Sensor Adapter (2-Bolt Style To Thread In Style) This kit will adapt a thread in style O2 sensor (18mm) to the Toyota two-bolt style. Includes gasket plate to adapt and two studs and nuts. Contact our Tech Support Line for further...

Header Stud Set The factory exhaust manifold studs have a shoulder in the center that can interfere with proper header tightening. Our 10mm x 48mm long, heat treated and plated header mounting studs are stronger than stock. Kit Includes: (8)...

Fan/Alternator Belt (1975 - 1995) Pickup & 4Runner 20R/22R/RE/RET This high Performance V-Belt is designed with being a workhorse in mind, the polyester cord provides maximum power transfer and tension holding capability for the life of the belt...

OEM Shifter Boot (Square) Over time the factory shift lever boot can get worn out or start to break down and disintegrate. When this happens it can result in dirt or mud getting into the transmission shifter housing and then into the transmission. This...

Brake Proportioning Valve Relocation Bracket Kit When you lift a Tacoma or Tundra, the Brake Proportioning Valve no longer senses loads properly and can cause a potentially dangerous braking situation. This kit relocates the Brake Proportioning Valve...

Oil Pan Gasket New oil pan gasket fits 20R, 22R, and 22RE engines from 1975-1984 with proper pan flanges. OEM quality for the best possible seal. NOTE: Gasket style flanges have a "dimple" up towards the block to "pinch" the gasket and create the...

Throttle Cable Up-Grade For custom applications such as sidedraft carburetors or race cars with different routing, this throttle cable end will make fabrication of a throttle cable a breeze. Simply cut the stock cable to length, attach this cable end...

Safety Auto Thrust Bearing Set (Standard) When overhauling/rebuilding an engine, it is highly recommended that you replace all bearings in the bottom end. These bearing sets will get your engine back to the proper specification and ready for the miles...

Underdrive Belt (6" Street Kit) This belt is used on the LC Engineering Pulley Kit for the 6" Water Pump and the 4" Crank Pulley with alternator assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

GT25 Turbo Discharge Gasket (5 Bolt) Stainless Steel GT25 Discharge Gasket. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174. Check out ...

Teflon Heat Isolation Gasket (Intake) Teflon Heat Isolator kits keep the power-robbing heat away from the intake air. By keeping the heat out of the intake manifold, the incoming air is cooler, therefore making more power. This is the ultimate for...

Axle Housing Breather (Replacement) Factory Toyota axle housing breather. Internal spring loaded flapper valve prevents water from entering through breather during water crossings. Stock replacement for old, rusted or damaged units. This product...