Year

Wheel Bearing Nut Kit (Front Hub) Normally the nuts that hold the wheel bearings can be reused over and over again. If your wheel bearing retainer nuts need replacing this kit is for you. Kit Includes: (2) Nuts (1) Star Washer (1) Flat Index...

PCV Relocation Kit If you're running an aftermarket carburetor on your 20R or 22R engine and you wish to retain the PCV system, you'll need a new place to run your rear PCV hose since the stock connection is part of the stock carburetor base plate...

Intake Manifold Stud Kit (Carbureted) This kit comes with all new studs to mount your carbureted manifold to your cylinder head. Replacing your stock intake bolts with studs will allow you to remove and reinstall your manifold numerous times without...

Fuel Injector Cups (w/ O-Rings) Fuel Injector Cups and O Rings for OEM Toyota 22RT-E fuel injectors. Located on the Intake Manifold for the injectors to sit in. Age and heat will take its toll on these plastic parts. They never come out whole and...

Oil Filter Housing Seal Kit (OEM) When removing the oil filter housing, it is always a good idea to replace these two O-ring seals. Any leak in this area can contaminate the system and affect oil pressure, not to mention the mess in the engine...

OEM Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. The bolt size is m16 x 1.50. It is recommended to use...

OEM "J" Bolt (Battery Hold Down) OEM Toyota "J" bolt for battery hold down bracket. OEM Toyota Part #: 74451-89103 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes...

Flange Dust Shield Dust shield for use with our triple drilled flange, see Part #: 2053174. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174...

10mm Rear Coil Spring Spacer (Old Man Emu) Features: Installs on the top of the rear coil spring. Designed to add 10mm lift to compensate for vehicle lean. NOTE: Sold Individually. Due to many supply chain issues, this product may be on backorder...

Street Distributor Cap New OEM style replacement distributor cap. A must when changing spark plug wires. Distributor caps can develop carbon tracks that can wreak havoc on the electrical path inside the distributor cap and cause drivability issues...

Water Pump Gasket (OEM) Gaskets seal and mate surfaces between various components to keep oil, coolant, air, and fuel in their respective places. Over time gaskets become brittle and break. Replace a leaky or corroded gasket before severe damage occurs...

CV Axle Inner Boot (Front) Replacement front axle shaft inner boot for 1986-1995 Toyota Pickup and 4-Runner with independent front suspension. Your Toyota's axle boots usually last the lifetime of your vehicle. However, they can tear which will allow...