Year

OEM Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. The bolt size is m16 x 1.50. It is recommended to use...

OEM "J" Bolt (Battery Hold Down) OEM Toyota "J" bolt for battery hold down bracket. OEM Toyota Part #: 74451-89103 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes...

Fuel Pressure Gauge "T" Fitting (5/16" Hose to 1/8" NPT) This fitting makes installing your fuel pressure gauge much easier. The fitting has an 1/8"npt "T" fitting along with two 5/16" hose barbs. This will allow you to install your fuel pressure...

Street Distributor Cap New OEM style replacement distributor cap. A must when changing spark plug wires. Distributor caps can develop carbon tracks that can wreak havoc on the electrical path inside the distributor cap and cause drivability issues...

Water Pump Gasket (OEM) Gaskets seal and mate surfaces between various components to keep oil, coolant, air, and fuel in their respective places. Over time gaskets become brittle and break. Replace a leaky or corroded gasket before severe damage occurs...

CV Axle Inner Boot (Front) Replacement front axle shaft inner boot for 1986-1995 Toyota Pickup and 4-Runner with independent front suspension. Your Toyota's axle boots usually last the lifetime of your vehicle. However, they can tear which will allow...

Street Valve Shim (Stock Bucket / 2.50mm - 2.85mm) Street valve shims are used to shim the valve lash to obtain the proper valve lash specification that is required for the appropriate camshaft grind. On 2RZ and 3RZ engines, the cam rides directly on...

Street Valve Shim (Stock Bucket / 2.90mm - 3.30mm) Street valve shims are used to shim the valve lash to obtain the proper valve lash specification that is required for the appropriate camshaft grind. On 2RZ and 3RZ engines, the cam rides directly on...

Underdrive Belt (Pro 7" Kit) This belt is used on the LC Engineering Pulley Kit for the 7" Water Pump and the 4" Crank Pulley without alternator assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Underdrive Belt (Pro 7" Kit) This belt is used on the LC Engineering Pulley Kit for the 7" Water Pump and the 4" Crank Pulley with alternator assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Oil Drain Fitting (Weld On -10AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This Steel fitting gets welded to the oil pan for the oil drain from the turbo. Contact our...

45° Oil Drain Fitting (1/2" NPT Male to -10AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil drain at the turbo or oil pan. Perfect for going...