Year

Exhaust Valve (Steel / Stock Size 36.5mm) If you're looking for replacement valves for your Toyota 22R/RE/RET engine, then these high-strength steel OE type replacement valves are just right for you. These valves utilize the factory size valve seats...

OEM PCV Valve (Steel) A Factory replacement OEM PCV valve with steel design straight up outlet. Use this PCV to replace the stock one that has the molded rubber hose. Don't forget the new PCV grommet, see Part #: 1024084 or the new hose from Toyota...

NGK Spark Plug R5672A-8 (10-18 Psi / 14:1 Comp) LC Engineering carries NGK V-Power spark plugs, which offer economical performance for your Toyota, and are the only plugs with NGK's V-Groove technology. They enhance the spark kernel, lower the voltage...

Spring Seat / Shim (Dual Springs) The LC Engineering 5VZ/1GR Pro Dual Valve Spring Seats are designed to be used with the Pro Dual Valve Springs. NOTE: Sold individually. This product should not be used in a manner that violates Federal EPA Laws...

Fuel Injector Top Grommets This is a new set of fuel injector grommets that go on the top of the fuel injector. Stop pesky fuel leaks at the fuel rail by replacing these grommets. NOTE: Sold as a set of (4). Contact our Tech Support Line for...

Round Collector Exhaust Gasket Set This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. In the stock application, two will be required, this is a kit and will include (2) gaskets. Alternate exhaust...

Tensioner Spring (Timing Belt) LC Engineering has the hard to find parts that are left out of most kits. This is the timing belt tensioner spring found on the 1988-1995 3VZ V6 Engines. OEM Part #: 90507-21001 Contact our Tech Support Line for...

Street Distributor Rotor The distributor rotor rotates inside the distributor and transfers the high tension current from the coil to the towers of the distributor cap. The firing end of the rotor, from which the high tension spark jumps to each of the...

CT-20 Turbo Stud Kit This stud kit was made to attach the CT-20 Turbo to the stock turbo manifold on your Toyota 22R-TE. If you find yourself needing to take apart a 20+ year old turbo setup, it is likely your old studs will be damaged or worn out. Why...

Teflon Heat Isolation Gasket (Throttle Body) Teflon Heat Isolator kits keep the power-robbing heat away from the intake air. By keeping the heat out of the intake manifold, the incoming air is cooler, therefore making more power. This is the ultimate...

Crank Trigger Magnet Individual replacement crank position sensor magnets for our Pro Fuel Injection kits. These magnets get installed in the balancer pulley and trigger the hall effect sensor to generate a signal for the ignition system. NOTE: Sold...

Teflon Heat Isolation Gasket (Throttle Body) Teflon Heat Isolator Kits keep the power-robbing heat away from the intake air. This is the ultimate for improving mileage and performance for the price. Installs between the throttle body and intake...