Street Performer Camshaft

LC Engineering's Street Performer Camshaft is an excellent upgrade to any mild engine application. This cam is also designed to work with the factory valve train components so you will not have to upgrade springs, retainers, etc... With a smooth idle and broad power band, this cam will allow your 22R/RE to run better and still retain its drivability. LC Engineering is constantly striving to improve both the quality and performance of our products. We test our camshafts on the street, race track and off-road. The results are an improved line of camshafts that offer a broader selection of grinds, increased horsepower, and higher quality.

LC Engineering is constantly striving to improve both the quality and performance of our products. We test our camshafts on the street, race track and off-road. The results are an improved line of camshafts that offer a broader selection of grinds, increased horsepower, and higher quality. All LC Engineering Camshafts are ground on new billets and double heat treated for long life. Each has been designed for maximum torque and horsepower, specifically for the application. When comparing camshaft profiles, always reference the duration @ .050" valve lift.

20R/22R - Street Performer Camshaft

2WD or 4WD Carb/EFI (1200-5000 rpm)
Smooth Idle, Torque Improvement

Intake Opens 6º BTDC

Intake Closes 30º ABDC

Exhaust Opens 49º BBDC

Exhaust Closes -10º BTDC

NOTE: LC Engineering highly recommends using our Pro Camshaft Kit to allow proper spring retainer to guide clearance for any cam that has over .450" lift or in any application that requires a sustained RPM of 6,000 or higher.

• Pro Camshaft Kit Part #: 1020000.
• Pro Camshaft Kit With Chromoly Retainers Part #: 1020007.

NOTE: LC Engineering will not warranty any cam damage if you do not purchase new Toyota rocker arms from LC Engineering, or a complete rocker arm assembly from LC Engineering at the same time as purchasing our camshaft.

• Individual rocker arms Part #: 1023015.
• Complete rocker assembly Part #: 1023018.

Buyer beware on reground rockers in the market. Regrinding the pad on the rocker can remove the heat treated portion of the pad making for a soft rocker. Rocker arms that are reground will not have the factory geometry of a stock rocker. To regrind a rocker will take care of the face surface but will do nothing to address the rocker shaft bore, a loose rocker bore will make adjustment difficult and will never be correct which is why we cannot warranty a camshaft unless new rockers are purchased with a camshaft.

Contact our Tech Support Line for further information at 928-855-6341.

Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!