-
Hardware Kit (Exhaust Flange) Exhaust hardware kit used on the two-bolt collectors in the header and exhaust kits. Kit Includes: (4) Mechanical locking nuts (M10 x 1.25mm) (4) Flange Bolts (M10 x 1.25mm x 40mm grade 10.9) NOTE: All hardware is...$9.88 -
Air Temp Plate (Adapts Cold Start Injector to Air Temp Sensor) Custom made plate to install an air temperature sensor where the cold start injector normally sits. Contact our Tech Support Line for further information at 928-575-2174...$9.85 -
LCE Performance Patch (5.5" Wide x 3" Tall) This is an LCE first! 2023 LCE Performance patch. Customize all your favorite gear from pull-overs to jackets to backpacks and more! Grab up the newest patch in the market right here at LCEPerformance.com...$9.55 -
LCE EGR Crossover Gasket LCE gasket for that EGR Crossover plate located on the back side of the cylinder head. NOTE: If you are looking to eliminate that EGR crossover, see Part #: 10320007 20R/22R/RE/RET EGR Crossover Block Plate Kit. Contact our...$9.51 -
Intake Manifold Gasket LC Engineering offers the best quality gaskets possible for your Toyota engine. Over time, the factory gaskets become brittle and break. Replace a leaky or corroded gasket before severe damage occurs! This kit contains the gasket...$9.42 -
Thermostat (160 Degree) There is really only one reason to run this thermostat. Race tracks that require vehicles to run water, no coolant, this is the thermostat you need. We would not recommend this for any vehicle running coolant. See our 180°...$9.27 -
Nylon Shift Lever Bushing (End of the Handle) If your shifter on your manual transmission is loose and sloppy, this bushing is in need of replacement. This is an OEM nylon cup that fits over the ball end of the shift lever (transmission side). We...$9.00 -
Round Collector Exhaust Gasket Set This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. In the stock application, two will be required, this is a kit and will include (2) gaskets. Alternate exhaust...$8.78 -
OEM Main Bolt (Cam Bolt) This is a brand new OEM Toyota main bolt. Ironically this is the same bolt used to hold the cam gear and distributor drive gear onto the front of the cam. Quantity 10 used for crank main caps.OEM Part #:...$8.60 -
3mm Allen Wrench (Ball Head) This 3mm allen wrench is used mainly for our TPS screw upgrade kit. The ball end of the wrench allows off angle access to the TPS screws. This makes adjusting the TPS a lot easier if you are doing it in the vehicle. NOTE:...$8.44 -
Crank Trigger Magnet Individual replacement crank position sensor magnets for our Pro Fuel Injection kits. These magnets get installed in the balancer pulley and trigger the hall effect sensor to generate a signal for the ignition system. NOTE: Sold...$8.19 -
-10 AN Fitting For Oil Catch Can AN 10 Fitting. Designed to work with our new catch can so you can use braided hose and AN fittings. -10AN ORB to -10AN$8.00
-
fast shipping
Speed Delivery