Fuel Injector Isolators (Bottom) To isolate injectors in the stock intake manifold LC Engineering suggests changing these when rebuilding the engine or when servicing the fuel injectors. LC Engineering flow-matched fuel injectors include new isolators...

Fuel Injector O-Rings Located on the fuel rail end of the injectors. LC Engineering suggests changing these when rebuilding or servicing the engine or the manifold assembly. LC Engineering flow-matched fuel injectors include new o-rings in the kit...

Fuel Injector Cups (w/ O-Rings) Fuel Injector Cups and O Rings for OEM Toyota 22RT-E fuel injectors. Located on the Intake Manifold for the injectors to sit in. Age and heat will take its toll on these plastic parts. They never come out whole and...

EFI Intake Bolt (Long) M8-1.25 x 95mm Socket Head Cap Screw for use on EFI intake. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174. Check out ...

Propane Injection Kit Our kits are designed to bolt onto the carbureted 22R and 20R motors and to use your existing carburetor throttle plates. These are excellent conversions, very simple and clean. Installation time should take 2 to 5 hours,...

Propane Injection Kit We now have a propane kit designed for the EFI engine! Lose that smashed up gas tank and poor drivability due to faulty sensors and old wiring with bad connections. Our kits are designed to bolt on to the factory throttle body and...

Manifold Adapter Gasket (Holley Adapter To 20R) Gaskets seal and mate surfaces between various components to keep oil, coolant, air, and fuel in their respective places. Over time gaskets become brittle and break. Replace a leaky or corroded gasket...

Sidedraft Manifold w/ Linkage (48mm & Larger Carbs) If you are running 48mm or larger sidedrafts then this is the manifold you need. The two-piece design allows the carburetors to be spread apart from each other so you don't get any linkage...

Idle Cut-off Solenoid This solenoid threads into the Electric Choke version of the Weber 32/36 carburetor and closes off the flow of fuel in the idle circuit when the ignition is cut. Contact our Tech Support Line for further information at...

Accelerator Pump Jet Replacement accelerator pump jet for the Weber DCOE (Sidedraft) carburetor. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not...

Throttle Body Extension (40mm) Use these extensions to provide a mounting surface for an air filter baseplate, beyond the fuel rails on 2900, 2930 and 3000 series throttle bodies. These components can also be used to extend the effective length of an...

Throttle Position Sensor (Sidedraft) Throttle position sensor for converting to sidedraft throttle body injection. If you would like to connect it to the wiring harness, see Part #: 1061095. NOTE: This throttle position sensor will not mount or...