Holley 350/500 to Weber Manifold (Adapter + Spacer Kit) We manufacture these billet aluminum carb spacers in house, to our specs. We use only the finest materials in our spacers to assure the quality you would expect from LC Engineering. These are CNC...

Pro Clutch + Flywheel Bundle Kit Kit Includes: Pro Clutch Kit (Pro Pressure Plate, Pro Clutch Disc, Throwout Bearing, Pilot Bearing and Alignment Tool) Flywheel of your choice OEM Pressure Plate Bolts OEM Flywheel Bolts Rear Crank Seal-Saver OEM Rear...

OEM Crankshaft Pulley (Outer) This Pulley is for vehicles equipped with power steering. If replacing your harmonic balancer, this will be a good idea to replace as well. This will bolt to the factory harmonic balancer and can be used when adding power...

Crankshaft Key Set (Woodruff Key) Crankshaft keys (also called Woodruff Keys) are semicircular shaped, removable keys that fit into matching keyways cut into the crankshaft leaving protruding tabs. These tabs mate with matching slots on the harmonic...

OEM Balancer Bolt We recommend replacing the balancer bolt any time you remove the harmonic balancer. Cheap insurance to avoid problems down the road. This is the OEM bolt with a large flange. The bolt size is m16 x 1.50. It is recommended to use...

Oil Filter Housing Seal Kit (OEM) When removing the oil filter housing, it is always a good idea to replace these two O-ring seals. Any leak in this area can contaminate the system and affect oil pressure, not to mention the mess in the engine...

OEM Heater Tube (Under EFI Manifold) This is OEM toyota part and should be replaced if yours is corroded. OEM Toyota Part #: 87208-35170 NOTE: Should be used w/ our Part #: 1060012. Contact our Tech Support Line for further information at...

Breather Hose (Front Of Valve Cover) OEM Toyota hose comes off the valve cover and goes to intake manifold. OEM Toyota Part #: 12262-35040 NOTE: Not for EFI applications. For EFI applications, see Part #: 1072415 (1984-1988), or Part #: 1072411...

Safety Auto Rod Bearing Set (.25mm / +.010″) When overhauling/rebuilding an engine, it is highly recommended that you replace all bearings in the bottom end. These bearing sets will get your engine back to the proper specification, and ready for the...

CT-20 Turbo Stud Kit This stud kit was made to attach the CT-20 Turbo to the stock turbo manifold on your Toyota 22R-TE. If you find yourself needing to take apart a 20+ year old turbo setup, it is likely your old studs will be damaged or worn out. Why...

Cross Drilled Slotted Rotors A moving vehicle has a large amount of kinetic energy, and the brakes have to remove this energy in order to stop. How do the brakes do this? Each time you stop, your brakes convert the kinetic energy to heat generated by...

Throttle Position Sensor Plug (w/ Wires) As time marches on Toyota will, little by little, discontinue parts it carries for the 22R/22RE powered trucks. We are here working hard to step in and make sure that the parts you need are still out there to...