Model

Exhaust Clamp (2 1/4") This 2-1/4" exhaust clamp allows you to attach your exhaust without welding. This makes the future removal of your exhaust system much easier. These are the clamps used on LC Engineering's Performance Exhaust Systems. It can be...

Spark Plug Wire Clip This is the replacement cage that will go around the boot at distributor to lock the spark plug wire onto the cap. This is for the OEM wires or LC Engineering's pro 8.5mm spark plug wires. We always recommend the use of our Race...

Distributor Drive Gear Spacer When eliminating the fuel pump eccentric from the stock distributor, you will need this spacer to bring the drive gear back into alignment. This is an OEM core unit processed by LC Engineering. Only used on 22R when...

Valve Keeper (Hardened) Hardened Valve Keepers fit all 6mm valves using stock Toyota retainers and our Pro Titanium Retainers. A must for high rpm applications! NOTE: Keepers are sold as a single set (per valve). Contact our Tech Support Line...

Round Collector Exhaust Gasket (2" OD 1.590" ID) This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. Stock applications will require (2). Alternate exhaust gasket sizes: 2.620" OD 1.950" ID, see...

Exhaust Manifold Stud and Nut When installing new aftermarket headers, new hardware should be used. An even clamping force is required to keep the header tight against the head in order to seal the exhaust gasket properly. The studs on your truck may...

Crankshaft Key Set (Woodruff Key) Crankshaft keys (also called Woodruff Keys) are semicircular shaped, removable keys that fit into matching keyways cut into the crankshaft leaving protruding tabs. These tabs mate with matching slots on the harmonic...

Vinyl Decal Set (22R Motor & Monster 4Runner) Decals increase horsepower! Not really, but you can show the person behind you why you're in front! New limited edition old school Toyota decals. Contact our Tech Support Line for further...

Straight Fitting (1/8" NPT to -4AN) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil feed at the block or turbo. Perfect for going from a 1/8" NPT hole...

Rear Main Seal Housing Gasket This gasket seals the rear main seal housing to the block on 20R-22RE engines. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images...

Turbo Water Bypass Gasket (CT20) This is a replacement for the OEM turbo water bypass Gasket for 22RET engines with the CT20 Turbo. NOTE: (2) Needed for turbo. Contact our Tech Support Line for further information at 928-575-2174. Note:...

Turbo To Oil Return Line Gasket (CT20) This is a replacement for the OEM turbo to oil return line gasket for 22RET engines with the CT20 Turbo. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for...