Model

T3 Turbo Inlet Gasket LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This stainless steel gasket has a crush ring to provide a perfect seal even if there are slight imperfections in...

LCE EGR Crossover Gasket LCE gasket for that EGR Crossover plate located on the back side of the cylinder head. NOTE: If you are looking to eliminate that EGR crossover, see Part #: 10320007 20R/22R/RE/RET EGR Crossover Block Plate Kit. Contact our...

45° Oil Drain Fitting (1/2" NPT Male to -8AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil drain at the turbo or oil pan. Perfect for going...

OE Breather Hose (Front Of Valve Cover) OE Toyota hose comes off the valve cover and goes to intake manifold. Replaces OEM Toyota Part #: 12262-35030 NOTE: Not for carbureted applications. For carb applications, see Part #: 1072413 (1984 only), or...

Throttle Body Gasket (Metal "D" Shape) Throttle body gaskets can be a source of hard-to-find vacuum leaks if the throttle body is removed or disrupted. Any time you remove your throttle body, you should replace the gasket while you're at it. This is...

Nylon Shift Lever Bushing (End of the Handle) If your shifter on your manual transmission is loose and sloppy, this bushing is in need of replacement. This is an OEM nylon cup that fits over the ball end of the shift lever (transmission side). We...

Tensioner Spring (Timing Belt) LC Engineering has the hard to find parts that are left out of most kits. This is the timing belt tensioner spring found on the 1988-1995 3VZ V6 Engines. OEM Part #: 90507-21001 Contact our Tech Support Line for...

Heavy Duty Shift Spring (Transfer Case) The stock transfer case shift springs tend to give a sloppy feel to the shifters and can lead to the transfer case shift lever popping out of gear on the trail. We recommend heavy duty shift springs be used with...

Axle C-Clip (Inner) This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are...

Birfield Snap Ring This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech...

Idle Air Compensator Valve O Ring This is the OEM rubber o ring gasket that is used on the 1995 to 2000 Toyota 3RZ throttle bodies for the IAC valve. What is an IAC it is an idle air compensator valve directly associated with the idle control on the...

Exhaust Valve (Steel / Stock Size 36.5mm) If you're looking for replacement valves for your Toyota 22R/RE/RET engine, then these high-strength steel OE type replacement valves are just right for you. These valves utilize the factory size valve seats...