Street Distributor Rotor The distributor rotor rotates inside the distributor and transfers the high tension current from the coil to the towers of the distributor cap. The firing end of the rotor, from which the high tension spark jumps to each of the...

Hub Outer Dial O-Ring (Aisin Manual Hubs) There is a small rubber O-ring located between the inner and outer hub dials. If this ring becomes damaged water and dust can leak into the hubs. It can also make turning the dial difficult. Easy to install...

Spark Plug Tube Seal This gasket seals the spark plug tube to the valve cover to keep oil from contaminating the spark plug boots. NOTE: Sold individually. Contact our Tech Support Line for further information at 928-575-2174. Note:...

8" Pinion & Transfer Case Flange Nut The flange nuts are recommended to be staked or peened over to lock so they are not considered reusable. This stock replacement nut is used on the 8" pinion in the rear 1979-2002 and most transfer case flanges...

Base Gasket (Pair) Avoid or fix annoying vacuum leaks by replacing the base gaskets between your carburetor and intake manifold. We recommend this genuine Red Line Weber gasket to be replaced any time the carburetor is removed from the manifold...

Primary Idle Jet Holder (w/ O-Ring) This Weber jet holder holds the primary fat jet into the main housing on Weber 32/36 and 38 downdraft carburetors. Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Secondary Idle Jet Holder (w/ O-Ring) This Weber jet holder holds the secondary skinny jet into the main housing on Weber 32/36 and 38 downdraft carburetors. Contact our Tech Support Line for further information at 928-575-2174. Note:...

Thermostat Housing Gasket (Round / Rubber) Any time you replace the thermostat or remove the housing, you should replace the gasket to avoid future leaks. This gasket is a round rubber O-ring style gasket that offers the best possible seal for your...

Round Collector Exhaust Gasket (2-Bolt x 2 1/2" Flange) If you plan to connect your header to the rest of your exhaust, you will need a collector gasket. OEM gaskets feature a carbon material and stainless steel fire ring for a long life and a positive...

Base Gasket (Pair) Avoid or fix annoying vacuum leaks by replacing the base gaskets between your carburetor and intake manifold. We recommend these gaskets to be replaced any time the carb is removed from the manifold. NOTE: This part will include 2...

NGK Spark Plug R5671A-9 (18-30 Psi / 14:1+ Comp) LC Engineering carries NGK V-Power spark plugs, which offer economical performance for your Toyota, and are the only plugs with NGK's V-Groove technology. They enhance the spark kernel, lower the voltage...

Round Collector Exhaust Gasket (2-Bolt x 2 1/4" Flange) If you plan to connect your header to the rest of your exhaust, you will need a collector gasket. OEM gaskets feature a carbon material and stainless steel fire ring for a long life and a positive...