Air Temp Plate (Adapts Cold Start Injector to Air Temp Sensor) Custom made plate to install an air temperature sensor where the cold start injector normally sits. Contact our Tech Support Line for further information at 928-575-2174...

Fuel Pump Relay Fuel pump Relay for Pro Fuel Injection Kits. Required for the computer to turn on the electric fuel pump. Much easier than having an additional switch on the dashboard! Contact our Tech Support Line for further information at...

Knock Sensor Upgrade This is for the upgrade for the newest Pro Fuel Kits using the SDS computer. The upgrade will come with the Knock Sensor and adapter. Knock control allows the ECU to retard the ignition timing automatically if knocking is detected...

Crank Trigger Magnet Individual replacement crank position sensor magnets for our Pro Fuel Injection kits. These magnets get installed in the balancer pulley and trigger the hall effect sensor to generate a signal for the ignition system. NOTE: Sold...

Fuel Injector Caps These black injector caps fit Type C & Turbo model injectors only. For installation, we recommend placing the caps in hot water then pushing them on to the injector. NOTE: Sold as a set of (4). For Type E or F caps, see Part #:...

Fuel Injector Isolators (Bottom) To isolate injectors in the stock intake manifold LC Engineering suggests changing these when rebuilding the engine or when servicing the fuel injectors. LC Engineering flow-matched fuel injectors include new isolators...

Fuel Injector O-Rings Located on the fuel rail end of the injectors. LC Engineering suggests changing these when rebuilding or servicing the engine or the manifold assembly. LC Engineering flow-matched fuel injectors include new o-rings in the kit...

Pro Air Fuel Tuning Module (Mixture Meter) The Pro Tuning Module gives you the ability to adjust the fuel curve in your 22RE. If your Air Fuel Ratio shows lean, turn the tuning module to a richer setting, it's just that simple. Contact our Tech...

Single Wire Oxygen Sensor (2-Bolt Style) With these trucks getting up in their ages and accumulating thousands of miles, chances are the factory O2 sensors are no longer as accurate as they used to be. Replace your old O2 sensor with one of these OE...

Garrett T3 / T4 Hybrid (Pro Turbo / Low Boost) The Garrett T3/T4 Hybrid turbo is the best of both worlds! The low inertia and fast boost response of the lightweight T3 turbine wheel combined with the high airflow characteristics of the T4 compressor...

Garrett T3 / T4 Hybrid (Pro Turbo / High Boost) The Garrett T3/T4 Hybrid race turbo is the next step up from our street turbo. These high-boost turbos share the same low inertia and T3 turbine wheel and T4 compressor to make this the best choice for...

Pro Turbo Kit (High Boost) LC Engineering's Turbo Kits are designed for use on the Toyota 22RE-powered trucks, 4Runners and Celicas. Whether it's for street use or competitive drag racing this is the kit to maximize the horsepower of the Toyota 22...