Tie Rod
(Choose Your Length)
Trail Gear's heavy duty tie rods are made from 1.25" x .250" wall DOM tubing, precision tapped with a left side thread mark. Each rod is test fitted to ensure rod ends thread in with correct fit. Powder coat black finish...
Steering Columns
3 1/4 Inches: This steering column will allow you to use your existing Toyota steering linkage without having to buy a coupler and then cut and weld on your steering shaft. This steering column measures 3 1/4 inches from the base of...
Steering Stabilizer
(Old Man Emu)
Designed to reduce the effect of wheel vibration and improve the feel, handling and control of the vehicle, OME's steering stabilizers will also reduce the aggressive rotation of the steering wheel over rough roads...
Steering Stabilizer Kit
(9.55" Stroke)
To reduce steering vibrations at higher speeds, a steering stabilizer can be very helpful. We offer a stabilizer kit that attaches above the drag link. One end welds to the passenger side frame rail and the other...
Steering Pump Kit Hoses
This kit contains one high pressure and three low pressure power steering lines. These lines are used to connect the pump, steering box and cooler together. The two hoses that go from the steering ram to the steering box are not...
Clevis End Kit
Our Clevis End Kit is the most complete and affordable kit on the market. All hardware is included along with the necessary spacers. The Clevis ends are clear zinc-plated for a sharp look and long lasting finish. This kit will fit most...
Power Steering Pump Bracket Kit
(Rock Assault)
This pump bracket is designed to adapt our "TC" style power steering pumps to your 75-95 Toyota 20R/22R/RE/RET engine. This bracket will utilize the stock idler pulley for the power steering belt.
NOTE:...
Ram Mounting Kit
(Double Ended)
This kit will take almost all the fabrication work out of mounting your Rock Assault Double Ended Ram and Clevis Kit to almost any axle housing. The main support tube is pre-bent and can be trimmed to size and coped on...
Power Steering Pump Bracket
This power steering pump brackets is designed for the TC style power steering pumps and include all applicable hardware.
NOTE: This is for the Trail Gear pumps not for stock applications. Parts shipped raw, and ready to...
Monroe Steering Stabilizer
The job of a steering stabilizer is to dampen bump-steer (when your truck hits an uneven surface on on side that causes it to turn on it's own) and reduce some vibration experienced in the steering wheel from uneven surfaces...
Power Steering Fluid Cooler
If you're running a high volume/pressure pump your system is generating much more heat then the stock system. Fluid overheating can cause damage to steering pump and steering box. Installing an oil cooler in front of the...
Power Steering Pump Pulley
(V-Belt)
This pulley is designed to fit our standard or full hydraulic power steering pumps.
NOTE: Not designed for the stock pump.
This product should not be used in a manner that violates Federal EPA Laws.
Contact...