Lower Shock Mounts These shock mounts are designed to weld directly onto the axle housing. These mounts can be used on front or rear axle applications. Made from 3/16" plate steel. Mounts have curved bottoms that can be mounted horizontally or...

Front Leaf Spring Hanger Kit (Extra-Flex Springs) Hanger kit allows of hanging of leaf springs on 1986-1995 Toyota Pick-Ups and 4Runners. Kit designed to work with many 3" - 6" lift aftermarket springs. Frame jigs make it easy to place shackle tubes in...

Leaf Spring Frame Tubes Frame Tubes install into IFS style frame for mounting leaf springs. Accepts stock Toyota front bushings. Jigs are used for positioning tubes in frame. This product should not be used in a manner that violates Federal EPA Laws...

Leaf Spring Frame Tube Jigs Frame Tubes install into IFS style frame for mounting leaf springs. Accepts stock Toyota front bushings. Jigs are used for positioning tubes in frame. This product should not be used in a manner that violates Federal EPA...

Track Bar Axle Mount Leaf springs can "wrap up" under the torque of rock crawling. Low gears and flexible springs are more susceptible to this effect. For most trail rigs, the wrap up does not present a problem. For those tackling the top trails and...

Johnny Joint 1.25" Rod End (Right Threaded) Forged Johnny Joint® rod ends feature forged steel construction, a 1 1/4"-12 right hand threaded shank and come fully assembled with our standard Johnny Joint internals (2.625" wide ball center with a...

Johnny Joint Jam Nut (Right Threaded) These jam nuts are good to have if you spend a lot of time working on your rock crawler suspension. These jam nuts tighten against the rod ends to keep them from loosening. 1 1/4"-12 right hand thread jam nut for...

3 Hole Spring Perches When installing lifted rear leaf springs, it's best to rotate the pinion so it points directly at the rear transfer case output flange and use a CV style drive shaft. The best way to rotate the pinion is to cut off the old perches...

Rear Shackle Mounts If you're installing longer rear springs you may need to relocate your rear shackle mount. You can do this by cutting off the original units with a die grinder and then welding them back on. You can also cut off the old ones and...

Shackle Bolt (Greasable) LC Engineering carries all the parts you need to change or rebuild your own shackles. Bolts feature threaded zerk fittings that won't fall out when you're greasing them. NOTE: Bolt is M18 x 150mm. For use with Trail Gear...

Shackle Nut (Stover) LC Engineering carries all the parts you need to change or rebuild your own shackles. Bolts feature threaded zerk fittings that won't fall out when you're greasing them. NOTE: Nut is M18 thread pitch. This product should not...

Shackle To Frame Bushing (Front & Rear) Is it time to replace your bushings on you Trail Gear Extra-Flex springs? These bushings go on the frame side of the spring shackle on both front and rear Extra-Flex springs. Alternate Bushings: Leaf spring...