1986

Weber Manual Choke Cable Are you looking to replace the manual choke cable on your Weber carburetor? Look no further LCE has you covered, we offer all of the genuine Weber/Redline replacement parts. This is the choke cable (58") overall with mounting...

K&N PCV Breather (62-1015)Not Recommended For Any Street Vehicle K&N crankcase vent filters are perfect for racing applications, vintage cars or individuals who want to add some aesthetics to their classic carbureted engine. The 62-1015 crankcase vent...

Valve Cover Gasket Set These valve cover gaskets feature precision edge-molded silicone rubber, which resists high heat and delivers reliable sealing on irregular surfaces. This silicone rubber is wrapped around a rigid carrier that adds strength to...

Throttle Position Sensor Plug (w/ Wires) As time marches on Toyota will, little by little, discontinue parts it carries for the 22R/22RE powered trucks. We are here working hard to step in and make sure that the parts you need are still out there to...

Heat Riser Tubing (1.5" x 36") This heat riser tubing is just what you need if you need to keep the choke plate on your carbureted engine hooked to the exhaust for emissions purposes. This tubing goes from the heat shield on the exhaust manifold to the...

OEM Clutch Release Fork Sub-Assembly OEM Toyota OEM Clutch Release Fork Sub-Assembly. OEM Toyota Part #: 31204-35031 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes...

Radiator Outlet Hose LC Engineering is now offering an OEM radiator outlet hose. OEM Toyota Part #: 16572-35030 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only...

Clutch Slave Cylinder The clutch slave cylinder is typically located on side of the transmission. The clutch slave cylinder receives hydraulic pressure from the clutch master cylinder which pushes the slave cylinder shaft out to actuate the clutch. One...

T3 Inlet Turbo Flange (4-Bolt) This flange is constructed of 1/2" steel and has threaded holes for easy installation of your turbo. It is designed for any turbo that uses a T3 style inlet flange. Don't see what you need? Just call our Technical Dept...

Toytec Axle Degree Shims These 3 degree shims bolt to the bottom of your leaf pack using the included new leaf spring center bolts. Axle degree shims are ideal for Add-A-Leaf and Leaf Pack installs to minimize or eliminate rear drive line vibration...

Wastegate Block Off Kit (40mm V-Band) Fits LC Turbo Manifold This kit is designed to block the 40mm wastegate on LC's turbo manifold when using a turbo outfitted with an internal wastegate. Contact our Tech Support Line for further information at...

Timing Chain Tensioner Need to replace your chain tensioner and don't need the entire kit? LCE has you covered! Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only...