Viton Valve Seals Viton Valve Seals are the latest in valve seal material, surpassing Teflon! Heat resistant to 440 degrees, they eliminate oil consumption through the valve guide and provide smoother engine idling by stopping manifold air and oil...

Blow Off Valve Weld On Fitting (Race Port) This weld-on adapter is designed to work with our blow of valves when installing on intake tubes. This adapter will fit our Race Port blow off valves only. This adapter will not fit our Kompact series, Vee...

Balance Shaft Bearing Remove & Install Tool This is a custom designed tool (machined from billet aluminum) for removing and installing balance shaft bearings in 3RZ and 2TR engines. Contact our Tech Support Line for further information at...

Stock Replacement U-Joint (Heavy Duty w/ Zerk) Looking for a top quality replacement U-Joint? This joint has been tested to 4,000 Ft.-Lbs. of torque in our axle testing machine. These joints are up to any task and will handle high output motors and low...

Wastegate Block Off Plate (CNC Turbo Manifold) This block off plate goes under the CNC Turbo manifold (2) Bolt Style. 3/8" thick Ceramic Coated to handle the heat from our CNC turbo manifold. Contact our Tech Support Line for further information...

2.32" ID Silicone Elbow (45º / Black) Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

2-Bolt Stub Connector (You Choose Size) 2 1/4" Flange This is a 2-bolt collector reducer to allow you to fabricate your own exhaust after our header. Bolts to our street header and has 2.25" stainless steel tubing to weld or clamp to. 2 1/2" Flange This...

Merge Collector (You Choose Size) You've got that header all constructed, now you just need a collector to tie it all together. LC Engineering has already done the work for you, just pick the one for your application, slip it on, and weld it up! These...

Garrett T3 Exhaust Discharge Flange (4-Bolt) Use 2.5" OD tubing in the groove or 3" OD tubing outside the groove. 3" OD is tight near the bolt holes but works fine so you're not limited to a 2.5" downpipe. Contact our Tech Support Line for...

Oil Fitting (28BSPT to 1/8"NPT Female) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This is a steel fitting that will come in a silver or gold zinc finish. the 1/8 fittings may seem...

OEM Exhaust Hardware Kit This kit will contain (2) Bolts and (2) Springs needed for installing your exhaust back on at the collector. Kit Includes: (2) 90080-10291 Bolts (2) 90080-50392 Springs Contact our Tech Support Line for further...

Intake Valve (Black Nitride w/ Anti Friction Coating / 37.5mm 1mm Over) These valves are 1MM larger than stock, great for ported heads that need more flow through the valves. These stainless steel valves are lighter than the stock steel valves and...