2.32" ID Silicone Elbow (45º / Black) Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

E-Boost Street Boost Controller (40 PSI) Racing technology for the street E-Boost street is an electronic boost controller aimed at the street performance market. It features many boost control capabilities found on its big brother the e-Boost2,...

Oil Feed Line (Stainless Steel Braided) Looking for a better oil feed line for your turbo? Look no further, LC Engineering has everything you need. This particular line was designed for our Turbo kits but it could be used for just about any application...

Oil Drain Line (Stainless Steel Braided) Looking for a better oil drain line for your turbo? Look no further, LC Engineering has everything you need. This particular line was designed for our Turbo kits but it could be used for just about any...

(1) NGK V-Power Spark Plug LFR7AIX2309 (1 Heat Range Cooler than Stock) NGK iridium plugs represent the ultimate evolution of spark plug technology and performance. The iridium center electrode is both stronger and harder than platinum. This allows NGK...

Fuel Pressure Gauge "T" Fitting (5/16" Hose to 1/8" NPT) This fitting makes installing your fuel pressure gauge much easier. The fitting has an 1/8"npt "T" fitting along with two 5/16" hose barbs. This will allow you to install your fuel pressure...

Heavy Duty Shifter Seat (White) It's common for the factory shift lever ball seat to wear, crumble and disintegrate over time. This often results in a sloppy or loose transmission shifter. The factory seat is soft so it can be squeezed into position...

Heavy Duty Shifter Seat (Blue) It's common for the factory shift lever ball seat to wear, crumble and disintegrate over time. This often results in a sloppy or loose t-case shifter. The factory seat is soft so it can be squeezed into position. These...

Wastegate Block Off Plate (CNC Turbo Manifold) This block off plate goes under the CNC Turbo manifold (2) Bolt Style. 3/8" thick Ceramic Coated to handle the heat from our CNC turbo manifold. Contact our Tech Support Line for further information...

Garrett T3 Exhaust Discharge Flange (4-Bolt) Use 2.5" OD tubing in the groove or 3" OD tubing outside the groove. 3" OD is tight near the bolt holes but works fine so you're not limited to a 2.5" downpipe. Contact our Tech Support Line for...

T3 Turbo Discharge Gasket (4 Bolt) Stainless Steel T3 Discharge Gasket. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174. Check out ...

JBA Exhaust (3" Single Exit) When it comes to performance exhaust systems, most people are looking for three things: Power, sound, and quality. JBA Exhaust Systems deliver all three, giving it both great looks and performance. One of the first...