-
Metal Backed Timing Chain Guides (Dual Row) Used on all 20r and 81-82 22r engines from the factory. LC Engineering uses factory OSK metal-backed guides to address the common breakage problem of the plastic guides on 83-84 factory single row engines...$26.73 -
Timing Cover Hardware (Dual Chain Applications) Timing Chain Bolt Kits for the early dual-row cover or the LC Engineering dual row conversion kit. All Hardware is zinc plated, or black oxide coated. This is the hardware used in the Timing Chain...$26.73 -
Timing Cover Hardware (Single Chain Kit) This kit is all the hardware you will need for the installation of the late model Timing Chain Cover in most applications. All hardware is zinc plated, or black oxide coated. NOTE: This kit will not address any...$26.73 -
Gasket Set (Timing Chain Cover) High-quality timing cover gasket set for (85-95) 22R and 22RE engines. Does not fit early (75-84) blocks, for those engines, use Part #: 1015045. Contact our Tech Support Line for further information at...$26.23 -
2.32" ID Silicone Elbow (45º / Black) Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...$25.70 -
Garrett T3 Exhaust Discharge Flange (4-Bolt) Use 2.5" OD tubing in the groove or 3" OD tubing outside the groove. 3" OD is tight near the bolt holes but works fine so you're not limited to a 2.5" downpipe. Contact our Tech Support Line for...$24.84 -
Oil Fitting (28BSPT to 1/8"NPT Female) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This is a steel fitting that will come in a silver or gold zinc finish. the 1/8 fittings may seem...$24.67 -
Micro Activation Switch & Bracket This micro-switch and bracket enables performance enthusiasts to activate solenoids, fuel pumps, and most anything else. A micro throttle switch can be used as either the primary method of activating a Nitrous...$24.57 -
Oil Pump Drive Spline (Single Row) If you're replacing the single timing chain on your early Toyota motor (83-84) with the more desirable dual-row chain, you will need a dual row drive spline to make it all work right. OEM Toyota Part #:...$24.46 -
Safety Auto Rod Bearing Set When overhauling/rebuilding an engine, it is highly recommended that you replace all bearings in the bottom end.These bearing sets will get your engine back to the proper specification and ready for the miles to come. The...$23.64 -
Engine Rebuild Oil Galley Plug Kit Every 20R/22R/RE/RET block and crankshaft have numerous oil port locations that need to be plugged off after cleaning. LC Engineering can supply you with all these hard to find plugs. Most engines have some sort of...$23.51 -
PCV Hose This is the OEM 22RE PCV hose for the PCV Valve on top of the valve cover. OEM Toyota Part #: 12261-35011 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only...$23.23
-
fast shipping
Speed Delivery