-
Stick Shift Boot (Twin T-case) This boot is designed to work with our Creepy Twin T-Case shifter (above). It features a flexible rubber shell with a steel bottom plate for mounting to your floor board. Great for keeping engine heat and smell out of the...$49.99 -
Transfer Case Shift Base If you are going for the multiple transfer cases setup, you will need shifters too! Great replacement for your old or broken Toyota stock shifter. NOTE: Does not include shifter, for shifter, see Part #: 2051665. This...$49.99 -
Axle Breather Relocation Kit This Breather Relocation Kit was specifically designed to relocate your rear axle breather when welding up a rear axle gusset or any type of mount or bracket. This kit uses our Creeper Breather to keep any dirt, mud, or...$49.99 -
OEM Clutch Release Fork Sub-Assembly OEM Toyota Shift Fork For Clutch Release. OEM Toyota Part #: 31204-20071 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only...$44.42 -
Stainless Steel 11" Clutch Line Don't get stuck with a leaking or inoperable clutch hydraulic system! This kit replaces the stock rubber line that extends down to your clutch slave cylinder.When your stock lines get old, the rubber starts to expand...$43.46 -
Transfer Case Shifter Boot (OEM) It's common for the factory transfer case boot to degrade over time, crumble and disintegrate. This often results in dirt and mud getting into the transfer case shifter then into the transfer case. This simple Factory...$40.16 -
Differential Stud Eliminator Kit When you come home after a trail ride, do you see oil leaking from the center of your axle housings? The stock axle housing studs may be pulling loose. No longer do you have to tap and drill the studs out and replace...$39.99 -
Solid Pinion Spacer Solid pinion spacers prevent loosening of the gear setup preload. Originally designed for older Toyota applications, Toyota stopped using them decades ago. Solid spacer and shims replace the crush sleeve. It takes a little longer...$39.99 -
Solid Pinion Spacer (High Pinion) Solid pinion spacers prevent loosening of the gear setup preload. Originally designed for older Toyota applications, Toyota stopped using them decades ago. Solid spacer and shims replace the crush sleeve. It takes a...$39.99 -
Matsuba Drive Shaft U-Joints (Stock Replacement) OEM Replacement U-Joint. We have tested these joints to 3700 ft-lbs of torque before failure. Includes four install clips and Zerk grease fitting. NOTE: Does not fit CV side of driveline. Contact...$39.99 -
OEM Clutch Release Fork Sub-Assembly OEM Toyota OEM Clutch Release Fork Sub-Assembly. OEM Toyota Part #: 31204-35031 Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes...$37.09 -
Clutch Slave Cylinder The clutch slave cylinder is typically located on side of the transmission. The clutch slave cylinder receives hydraulic pressure from the clutch master cylinder which pushes the slave cylinder shaft out to actuate the clutch. One...$36.76
-
fast shipping
Speed Delivery