-
Axle C-Clip (Inner) This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. Contact our Tech Support Line for further...$6.99 -
Birfield Snap Ring This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. This product should not be used in a manner...$6.99 -
Pilot Bearing The crankshaft pilot bearing does not require routine maintenance, but should be replaced when clutch replacement becomes necessary. In some cases, pilot bearings can wear excessively...$6.46 -
Hub Outer Dial O-Ring (Aisin Manual Hubs) There is a small rubber O-ring located between the inner and outer hub dials. If this ring becomes damaged water and dust can leak into the hubs. It can...$6.32 -
Drive Shaft Bolt Flange Nut Replacement drive shaft bolts, nuts and washers. Bolts include factory thread lock adhesive already applied to threads. NOTE: Sold individually. See Part #:...$5.99 -
OEM Knuckle Stud Factory Toyota knuckle hardware. Don't let knuckle stud failure ruin your day, get the best. NOTE: Sold Individually. Â Â Â Contact our Tech Support Line for further information at...$5.99 -
OE Knuckle Cone Washer Factory Toyota knuckle hardware. Don't let knuckle stud failure ruin your day, get the best. NOTE: Sold Individually. Contact our Tech Support Line for further...$5.99 -
Precision Clutch Alignment Tool Ensure a seamless transmission installation with our Heavy-Duty Clutch Alignment Tool. Specifically designed to take the guesswork out of your clutch job, this tool...$5.36 -
Rear Axle Wheel Stud These wheel studs are for rear axle application and has M12 X 1.50 threads. NOTE: Solid axle only. This product should not be used in a manner that violates Federal EPA...$5.31 -
Drive Shaft Bolt Replacement drive shaft bolts, nuts and washers. Bolts include factory thread lock adhesive already applied to threads. NOTE: Sold individually. See Part #: 2053170 for drive...$4.99 -
8" Pinion & Transfer Case Flange Nut The flange nuts are recommended to be staked or peened over to lock so they are not considered reusable. This stock replacement nut is used on the 8" pinion in...$4.99 -
Shift Detent Bolt (Heavy Duty Transfer Case) The stock transfer case shift springs tend to give a sloppy feel to the shifters and can lead to the transfer case shift lever popping out of gear on...$4.99
-
fast shipping
Speed Delivery