Odds and Ends

Steering Pump Kit Hoses This kit contains one high pressure and three low pressure power steering lines. These lines are used to connect the pump, steering box and cooler together. The two hoses that go from the steering ram to the steering box are not...

Steering Box Mount /Reinforcement (IFS Steering Box) If you're installing crossover steering on your 79-85 4wd Toyota you're going to need to mount an IFS steering box. Angled leading and trailing edges prevent frame cracking. Heavy duty design with a...

Power Steering Pump Bracket Kit (Rock Assault) This pump bracket is designed to adapt our "TC" style power steering pumps to your 75-95 Toyota 20R/22R/RE/RET engine. This bracket will utilize the stock idler pulley for the power steering belt. NOTE:...

Ram Mounting Kit (Double Ended) This kit will take almost all the fabrication work out of mounting your Rock Assault Double Ended Ram and Clevis Kit to almost any axle housing. The main support tube is pre-bent and can be trimmed to size and coped on...

Power Steering Fluid Cooler If you're running a high volume/pressure pump your system is generating much more heat then the stock system. Fluid overheating can cause damage to steering pump and steering box. Installing an oil cooler in front of the...

Power Steering Pump Pulley (V-Belt) This pulley is designed to fit our standard or full hydraulic power steering pumps. NOTE: Not designed for the stock pump. This product should not be used in a manner that violates Federal EPA Laws. Contact...

Rod End (You Choose Size) Don't be fooled by look a like rod ends, they are not all the same. These rod ends are the strongest on the market, tested, and proven. The main body of this rod end is 100% 4340 chromoly and then finished with a zinc coating,...

FJ-80 Tie Rod End (RH / LH Thread) Heavy duty FJ-80 tie rod ends are ideal for Toyota crossover steering applications. These rod ends are greaed for life and sealed. It will include the cotter pin and jam nut. M23 X 1.5 This product should not be used...

Ram Clamp (w/ Weldable Mount) These mounts are designed to mount your TG Rock Assault™ Double Ended Ram to almost any location on your rig. The clamps have a 2.5″ ID and the Weld-On Mount is made out of 1020 billet steel. These Weld-On Ram Mounts are...

Steering Rod Bungs (Weld In) Finally a weld in bung with the thread pitch of an FJ80 Tie Rod Ends, which is the most commonly used Tie Rod Ends in Toyota hi-steer kits. Once welded into your tie rod or drag link, this bung will allow you to make a...

IFS Steering Box Fitting (Low Pressure) This is a Trail Gear low pressure IFS steering box fitting. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174...

Rock Assault Steering Stops A good set of steering stops is critical so that your steering does not over travel and damage other steering or axle components. Our Rock Assault steering stops are machined from solid billet so you will never have to worry...