Rubber Tailpipe Hanger (2-Hole) Factory replacement rubber insulator for tailpipe. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the...

Rubber Tailpipe Hanger (3-Hole) Factory 3 Hole replacement rubber insulator for tailpipe. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent...

Weld On Bung & Plug Kit (Thread-In Bosch Style) If you are installing an oxygen sensor in a system that didn't originally come with one, or if you are installing a stand-alone Wideband AFR gauge, you will need this kit. It comes with the bung (18mm...

Weld-On Oxygen Sensor Flange (2-Bolt Flange Style) This flange is made from 3/8" mild steel, then tapped for M8 x 1.25 studs weld on. For the 2 bolt style O2 sensor. NOT for thread-in O2 sensors. Contact our Tech Support Line for further...

Round Collector Exhaust Gasket (2" OD 1.590" ID) This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. Stock applications will require (2). Alternate exhaust gasket sizes: 2.620" OD 1.950" ID, see...

Heat Riser Tubing (1.5" x 36") This heat riser tubing is just what you need if you need to keep the choke plate on your carbureted engine hooked to the exhaust for emissions purposes. This tubing goes from the heat shield on the exhaust manifold to the...

Heat Riser Kit (Attaches Heat Riser To Air Cleaner) This kit is used to connect a heat riser tube to the stock air cleaner assembly. This kit can be used on any header with 1.5" primary tubes. Kit Includes: (3) Hose clamps (1) 1.5″ Standoff (1)...

Oxygen Sensor Adapter (2-Bolt Style To Thread In Style) This kit will adapt a thread in style O2 sensor (18mm) to the Toyota two-bolt style. Includes gasket plate to adapt and two studs and nuts. Contact our Tech Support Line for further...

Round Collector Exhaust Gasket Set This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. In the stock application, two will be required, this is a kit and will include (2) gaskets. Alternate exhaust...

Exhaust Manifold Stud and Nut When installing new aftermarket headers, new hardware should be used. An even clamping force is required to keep the header tight against the head in order to seal the exhaust gasket properly. The studs on your truck may...