Injectors

Cold Start Injector Service NOTE: Customer is responsible for paying postage to send their cold start injector to LC Engineering. Be sure to include the following with your injectors: Name (First & Last) Return Shipping Address Sales Order...

Fuel Injector Cup Set When rebuilding your cylinder head or servicing your fuel system, don't risk performance-robbing vacuum leaks by reusing worn-out factory hardware. Unlike previous engine generations, these fuel injector cups are located directly in...

Fuel injector Cup & O-Ring Set | Single Cylinder When performing minor repairs, servicing a single cylinder, or replacing damaged hardware during a top end tear down, don't risk performance-robbing vacuum leaks by reusing worn factory seals. This...

Fuel Injector Rebuild Kit Located on the fuel rail end of the injectors. LC Engineering suggests changing these when rebuilding or servicing the engine or the manifold assembly. LC Engineering flow-matched fuel injectors include all new parts in the...

Fuel Injector Caps (Green Cap) These clear injector caps fit 3VZ V6 injectors. For installation, we recommend placing the caps in hot water then pushing them on to the injector. NOTE: Sold as a set of (6). Contact our Tech Support Line for...

Fuel Injector Rebuild Kit LC Engineering suggests changing these when rebuilding or servicing the engine or the manifold assembly. Don't forget the cap end which is sold separately, there are two different styles depending on your year so make sure to...

Fuel Injector Isolators (Bottom) To isolate injectors in the stock intake manifold LC Engineering suggests changing these when rebuilding the engine or when servicing the fuel injectors. LC Engineering flow-matched fuel injectors include new isolators...

Fuel Injector Top Grommets This is a new set of fuel injector grommets that go on the top of the fuel injector. Stop pesky fuel leaks at the fuel rail by replacing these grommets. NOTE: Sold as a set of (4). Contact our Tech Support Line for...

Fuel Injector O-Rings Located on the fuel rail end of the injectors. LC Engineering suggests changing these when rebuilding or servicing the engine or the manifold assembly. LC Engineering flow-matched fuel injectors include new o-rings in the kit...