Fuel Pressure Gauge Kit
(EFI)
Ever wonder if the fuel regulator is doing its job? Not sure if you're getting the right fuel pressure at the fuel rail? This new fuel gauge kit is the solution to this problem. This kit will replace the banjo bolt on the cold start injector with a new stainless steel bolt that accepts a 1/8 NPT gauge. Included in this kit are the copper crush washers, elbow to face gauge forward, and 0-60 PSI Gauge that is 1.5".
NOTE: This gauge is intended to be used like a tool. Premature failure may result from leaving the gauge installed under hood. Not for use in the cabin of the vehicle. For the bolt only (with no gauge or elbow), see Part #: 1093076.
This product should not be used in a manner that violates Federal EPA Laws.
Contact our Tech Support Line for further information at 928-855-6341.
Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!
Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.
|