-
Heavy Duty Shift Spring (Transfer Case) The stock transfer case shift springs tend to give a sloppy feel to the shifters and can lead to the transfer case shift lever popping out of gear on the trail. We recommend heavy duty shift springs be used with...$6.99 -
Axle C-Clip (Inner) This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are...$6.99 -
Birfield Snap Ring This snap ring goes on the outer stub shaft of your birfield and keeps the birfield from drifting too far into the axle assembly. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech...$6.99 -
Oil Drain Plug (Small) The LCE 20R/22R small oil drain plug is manufactured from high-quality materials to handle the most challenging conditions. LCE drain plugs and gaskets are the quality parts you need to do your job right. The head is 14mm, and...$6.62 -
Pilot Bearing The crankshaft pilot bearing does not require routine maintenance, but should be replaced when clutch replacement becomes necessary. In some cases, pilot bearings can wear excessively when mounting bolts loosen. Contact our Tech...$6.46 -
Tie Rod Boots (Pair) At last it is possible to replace a damaged tie rod dust boot without having the expense of buying an entire new tie rod! These boots resist damage from rocks, sand, water, road salt, and oils better than many other O.E.M. rubber...$6.38 -
Hub Outer Dial O-Ring (Aisin Manual Hubs) There is a small rubber O-ring located between the inner and outer hub dials. If this ring becomes damaged water and dust can leak into the hubs. It can also make turning the dial difficult. Easy to install...$6.32 -
Drive Shaft Bolt Flange Nut Replacement drive shaft bolts, nuts and washers. Bolts include factory thread lock adhesive already applied to threads. NOTE: Sold individually. See Part #: 2053168 for drive shaft bolt and Part #: 2053170 for the...$5.99 -
OEM Knuckle Stud Factory Toyota knuckle hardware. Don't let knuckle stud failure ruin your day, get the best. NOTE: Sold Individually. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are...$5.99 -
OE Knuckle Cone Washer Factory Toyota knuckle hardware. Don't let knuckle stud failure ruin your day, get the best. NOTE: Sold Individually. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for...$5.99 -
Heater Tube O-Ring (Under EFI Manifold) The O-ring seals the heater tube under the EFI intake manifold. Over time O-rings become brittle and break. Replace a leaky or corroded O-rings before severe damage occurs. This is OEM toyota part and may not...$5.85 -
Turbo Compressor Outlet Gasket (CT20) This is a replacement for the OEM turbo compressor outlet gasket for 22RET engines with the CT20 Turbo. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line...$5.70
-
fast shipping
Speed Delivery