20R Intake Manifold Plug Kit

This plug kit comes with all the necessary plugs for a Cannon Intake Manifold. There are two holes that need this shouldered plug to seal. If you look at the picture you will see that there is a "step" in the hole that the shoulder seals on. If you use a straight plug on these holes it will not seal properly.

NOTE: This is for a 20R motor only running either the Stock or Cannon Intake Manifold. You may have a few plugs left over with the stock manifold. If you need the kit for a 22R then you will need Part #: 1032050, if you are wanting a kit for EFi then you will need Part #: 1032052.

This product should not be used in a manner that violates Federal EPA Laws.

Contact our Tech Support Line for further information at 928-855-6341.

Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!