Fuel Pressure Gauge Kit
Ever wonder if the fuel regulator is doing its job? Not sure if you're getting the right fuel pressure at the fuel rail? The new 95-04 2RZ/3RZ fuel gauge kit is the answer to those questions. This kit comes with everything you need to install it.
NOTE: LC recommends using fuel safe Teflon tape or Permatex Permasheild to prevent leaks from occurring when installing the product. Will not fit on supercharged applications without some modifications and extra adapters. This gauge is intended to be used as a tool. Premature failure may result from leaving the gauge installed under the hood. Not for use in the cabin of the vehicle.
This product should not be used in a manner that violates Federal EPA Laws.
Contact our Tech Support Line for further information at 928-855-6341.
Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!
|
Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.
|
To open a printable PDF version of this instruction
CLICK HERE
Kit Contents:
- (1) - LCE EFI Low Pressure Fuel Gauge
- (1) - LCE Fuel Rail Block
- (1) - 90 Degree Elbow Fitting
- (2) - Washers M6
- (2) - M6 x 1.00 Bolts
- (1) - O-Ring For Fuel Block
When installing any gauge or fitting into the fuel rail bolt, the bolt will need to be secured by a wrench when installing any components, Otherwise damage may occur on the fuel rail bolt if it is not properly supported when additional parts are installed. Fuel Pressure bolt should be torqued to no more than 22ft lbs. Check and inspect for any leaks.
NOTE: LC recommends using fuel safe Teflon tape or Permatex Permasheild to prevent leaks from occurring when installing the product. This gauge is not intended to be left installed under hood. After every tune / use, remove gauge and install plug (supplied). Failure to remove gauge will result in gauge failure.
