Weber Fuel Pump
This pump will maintain performance with Weber carburetors for all street performance and off-road applications. This fuel pump will meet the performance demands of dual or single carburetor applications. For use on engines with up to 200 HP and standard pressure, high-volume 6 psi, 25 gph (requires a pressure regulator). Includes inlet fitting (5/16" barbed) and outlet fitting (5/16" barbed).
This is an electric fuel pump that will need a 12-volt power and ground and is best mounted close to the fuel tank. It is also recommended to run a fuse and relay as the pump will draw 6 amps at wide-open throttle. If you will be installing this on an engine that is factory EFI that you are converting to Carb, we always recommend removing the EFI fuel pump from the fuel tank and extending the fuel line further into the tank. Always install a fuel filter prior to a fuel pump to protect it from contaminants in the fuel tank.
NOTE: When used on a Weber carb, this pump requires the use of a fuel pressure regulator, see Part #: 1035043. The Large Terminal is Ground, Small Terminal is Positive on this Pump.
This product should not be used in a manner that violates Federal EPA Laws.
Contact our Tech Support Line for further information at 928-855-6341.
Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!
Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.