Pro Flow Exhaust System 2nd Generation 4Runner 1990-1995

All of our Pro Flow Exhaust Systems are made with 409 stainless steel tubing, 426 stainless steel straight-through Magnaflow muffler and 3/8" thick mild steel flanges. The straight-through design of the Magnaflow muffler offers the highest flow while still maintaining a smooth, yet authoritative tone without attracting unwanted attention. They are then ceramic coated for long lasting good looks and protection from the elements. LCE designs our kits to be a direct fit application that requires little or no modifications, and uses factory exhaust hanger locations. This bolts up behind your factory catalytic converter or one of our high flow performance catalytic converters. This exhaust system features 2 1/4" tubing with a 3" polished stainless tip. Every kit is shipped complete with all the instructions and hardware you will need for a quick and easy installation process. This system will fit both 22R/RE and 3VZ V6 trucks when a 17.5" catalytic converter is used. We have the correct length converters available as well.

Fitment Notes:

4Runner 1990-1995 with coil spring rear end only.
Designed to be used with a 17" catalytic converter.

Contact our Tech Support Line for further information at 928-855-6341.

Check out www.LCEngineering.com for New Products, Tech Articles,
Specials & Monthly Newsletters!

Note: Images are for illustration purposes only. Images MAY NOT represent the product listed. Please contact Customer Service with any questions or concerns: 928-505-2501.

Average Customer Review:

4.5 of 5 Total Reviews: 3 Write a review.

0 of 0 people found the following review helpful:

Excellent product	March 7, 2019
Reviewer: Albert Lloyd from Hamilton , OH United States

Easy to install, zero fitment issues, all the hardware was top of the line and fit perfectly.

Was this review helpful to you?

0 of 0 people found the following review helpful:

CAT BACK	February 22, 2018
Reviewer: Henry Trumble Jr from Parker, CO United States

Recently purchased the complete exhaust for my 2D Gen 4-Runner. All components were perfect and installed with little to no trouble. Only issue was getting everything from the header to the tail pipe was the connector pipe. The Cat back system mentioned it worked with the 17" CAT. Replacing everything I went with the 17" CAT (mine was 12"). My issues was the connector pipe between the header and CAT had to be trimmed to fit properly. Other than that, perfection in every way.

Was this review helpful to you?

0 of 0 people found the following review helpful:

Pro Flow Exhaust System 4Runner 1989-1995	October 9, 2013
Reviewer: Rick Barrow from Elgin, TX United States

This was not the only item I ordered however, This exhaust system is easy to install and sounds great! Especially when you get the matching cat! I'm giving it 4.5 stars because the nuts and bolts that were included were impact style and either stripped as they got further on the bolt with tightening or snapped before getting near closing the gap or tightening all the way. I was able to find fine thread grade 8 replacements and used lock washers to make sure they don't come loose. I would have appreciated a note in the description if not including the need for a Block-Off Plate kit for those who own non-compliant/49 state models with no downstream O2 sensor. Thanks again for your excellent customer service and services!

Was this review helpful to you?