Valve Cover Gasket Set These valve cover gaskets feature precision edge-molded silicone rubber, which resists high heat and delivers reliable sealing on irregular surfaces. This silicone rubber is wrapped around a rigid carrier that adds strength to...

Steel Head Shim (+.020") For heads that have been milled beyond factory spec, we offer head gasket shims to bring the compression ratio back to where it should be. This will also prevent timing chain length issues that are common with severely milled...

PCV Grommet New PCV grommet for valve cover on 20R, 22R, and 22RE engines. Be sure to replace the grommet whenever you replace the PCV valve. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for...

Throttle Body Gasket Throttle body gaskets can be a source of more issues then they are often given credit for. Anytime you remove your throttle body it is best to replace the gasket because tiny imperfections you may not see can cause vacuum leaks...

Distributor Shaft O-Ring O-ring that seals the distributor shaft to the cylinder head. Keeps oil from leaking out and debris from getting in and contaminating the oil system. Contact our Tech Support Line for further information at 928-575-2174...

MLS Head Gasket (Custom Thickness / Bore) The cylinder head gasket is arguably the most critical seal in an automotive engine. Since the release of the internal combustion engine, gasket designers have specified many materials to meet this critical...

Teflon Heat Isolation Gasket (Intake) Teflon Heat Isolator kits keep the power-robbing heat away from the intake air. By keeping the heat out of the intake manifold, the incoming air is cooler, therefore making more power. This is the ultimate for...

Idle Air Compensator Valve O-Ring This is the OEM rubber o ring gasket that is used on the 1989 to 1995 Toyota 22RE throttle bodies for the IAC valve. What is an IAC it is an idle air compensator valve directly associated with the idle control on the...

Heater Tube O-Ring (Under EFI Manifold) The O-ring seals the heater tube under the EFI intake manifold. Over time O-rings become brittle and break. Replace a leaky or corroded O-rings before severe damage occurs. This is OEM toyota part and may not...

OEM EGR Crossover Gasket OEM Gasket for that EGR Crossover plate located on the back side of the cylinder head. OEM Toyota Part #: 11182-35050 Contact our Tech Support Line for further information at 928-575-2174. Note: Images...

Throttle Body Rebuild Kit Have an old worn out throttle body? Well, you are in luck! We have developed this kit that includes a new throttle body gasket, new shaft seals, and LC Engineering's own idle speed screw so you can rebuild yours. Call and...

LCE EGR Crossover Gasket LCE gasket for that EGR Crossover plate located on the back side of the cylinder head. NOTE: If you are looking to eliminate that EGR crossover, see Part #: 10320007 20R/22R/RE/RET EGR Crossover Block Plate Kit. Contact our...