GT25R Turbo Inlet Gasket (Metal) A Stainless Steel inlet gasket for the GT25 turbos that we use in our CT20 conversion kit. For between the turbo manifold and the GT25 turbo or our adaptor and the GT25. Contact our Tech Support Line for further...

T3 Turbo Discharge Gasket (5 Bolt) Stainless Steel T3/T4 Discharge Gasket. Contact our Tech Support Line for further information at 928-575-2174. Note: Images are for illustration purposes only. Images may not represent the product listed...

45° Oil Drain Fitting (1/2" NPT Male to -10AN Male) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This fitting is used for the oil drain at the turbo or oil pan. Perfect for going...

3.00" ID Silicone Elbow (45º / Black) Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

2.32" ID Silicone Elbow (45º / Black) Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

Oil Drain Line (Stainless Steel Braided) Looking for a better oil drain line for your turbo? Look no further, LC Engineering has everything you need. This particular line was designed for our Turbo kits but it could be used for just about any...

Garrett T3 Exhaust Discharge Flange (4-Bolt) Use 2.5" OD tubing in the groove or 3" OD tubing outside the groove. 3" OD is tight near the bolt holes but works fine so you're not limited to a 2.5" downpipe. Contact our Tech Support Line for...

T3 Turbo Discharge Gasket (4 Bolt) Stainless Steel T3 Discharge Gasket. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174. Check out ...

5/8" High Temperature Hose (Order By The Foot) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This 5/8" hose is perfect as an oil drain line for your turbocharger. Sold by the foot if...

GT25 Turbo Discharge Gasket (5 Bolt) Stainless Steel GT25 Discharge Gasket. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174. Check out ...

Oil Feed Fitting Kit LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. Kit Includes: (1) 12mm Banjo Bolt (1) - 4 AN Banjo Fitting (2) 12mm Copper Crush Washers Contact our...

T-Bolt Hose Clamp (You Choose Size) Our T-Bolt clamps are all 100% Stainless Steel to stand up to all weather conditions to protect against corrosion. Each clamp has rounded smooth band edges to prevent cutting into you silicone hoses. Engineered and...