Gaskets / Hardware

Street Header Gasket Set This gasket set is specifically for the 2TR (2.7L / 4 cylinder) engine. We only use the OEM stainless steel header gaskets, this ensures that you get the best seal on your...

Collector Gasket LC Engineering only uses factory Toyota exhaust gaskets on the 2TR Exhaust or our Street Header. This ensures that you get the best seal on your exhaust with no chance of burning...

Exhaust Gasket OEM Toyota gaskets offer the best possible seal for your stock manifold or header. All the LC Engineering headers are designed to use the factory style gaskets. Traditional paper...

OEM Exhaust Hardware Kit This kit will contain (2) Bolts and (2) Springs needed for installing your exhaust back on at the collector. Kit Includes: (2) 90080-10291 Bolts (2) 90080-50392...

OEM Exhaust Hardware Kit This kit will contain (2) Bolts and (2) Springs needed for installing your exhaust back on at the collector. Kit Includes: (2) 90080-10291 Bolts (2) 90501-A0031...

Header Stud Set The factory exhaust manifold studs have a shoulder in the center that can interfere with proper header tightening. Our 10mm x 48mm long, heat treated and plated header mounting...

Oxygen Sensor Adapter (2-Bolt Style To Thread In Style) This kit will adapt a thread in style O2 sensor (18mm) to the Toyota two-bolt style. Includes gasket plate to adapt and two studs and nuts...

Weld On Bung & Plug Kit (Thread-In Bosch Style) If you are installing an oxygen sensor in a system that didn't originally come with one, or if you are installing a stand-alone Wideband AFR gauge,...

Oxygen Sensor Install Kit (2-Bolt Style) This kit contains everything you need to install the factory 2-bolt O2 sensor into your custom exhaust. It allows you to weld in the O2 sensor wherever you...

Rubber Tailpipe Hanger (3-Hole) Factory 3 Hole replacement rubber insulator for tailpipe. Contact our Tech Support Line for further information at 928-575-2174.

Weld-On Oxygen Sensor Flange (2-Bolt Flange Style) This flange is made from 3/8" mild steel, then tapped for M8 x 1.25 studs weld on. For the 2 bolt style O2 sensor. NOT for thread-in O2 sensors...

Rubber Tailpipe Hanger (2-Hole) Factory replacement rubber insulator for tailpipe. Contact our Tech Support Line for further information at 928-575-2174. Note