Garrett T3 Exhaust Discharge Flange (4-Bolt) Use 2.5" OD tubing in the groove or 3" OD tubing outside the groove. 3" OD is tight near the bolt holes but works fine so you're not limited to a 2.5" downpipe. Contact our Tech Support Line for...

Oil Fitting (28BSPT to 1/8"NPT Female) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This is a steel fitting that will come in a silver or gold zinc finish. the 1/8 fittings may seem...

Black Silicone Adapter (2" to 2.75") Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

2" ID Silicone Elbow (90º / Black) Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

2.75" ID Silicone Elbow (45º / Black) Our silicone hose is the high performance choice for Turbo Intercooler or Air! Dress up your engine compartment by replacing your air lines with the highest quality silicone hose available! Full vacuum through the...

Silicone Adapter (2" to 2.5") Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...

Turbo Oil Drain Plate (1/2" NPT Boss / Turbo Side) LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. This drain plate mounts to the bottom of the turbo and gives you a 1/2" NPT bung to...

T3 Turbo Discharge Gasket (4 Bolt) Stainless Steel T3 Discharge Gasket. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174. Check out ...

GT25 Turbo Discharge Gasket (5 Bolt) Stainless Steel GT25 Discharge Gasket. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174. Check out ...

Oil Feed Fitting Kit LC Engineering carries all the components you need to build your own turbo kit or service your LC Engineering Kit. Kit Includes: (1) 12mm Banjo Bolt (1) - 4 AN Banjo Fitting (2) 12mm Copper Crush Washers Contact our...

Turbo Oil Drain Plate (w/ 1/2" NPT Boss For Block Side) Provides a 1/2" NPT port for a custom oil drain fitting. Eliminates the need to use the hard-to-find factory thread fitting that comes from the factory. Contact our Tech Support Line for...

Silicone Adapter (2.5" to 3") Our silicone hose is the high performance choice for vacuum hose! Dress up your engine compartment by replacing your vacuum lines with the highest quality silicone hose available! Full vacuum through the following...