Vintage restoration and OEM-replacement parts for the Toyota Trekker — the rare 22R-powered Winnebago/Toyota collaboration that predated the 4Runner nameplate. Engine components, body, suspension, and the hard-to-find pieces that keep these original Trekkers alive.
Rear Seal Gasket Assembly
High-quality silicone seals with a double lip for improved sealing, includes rear main seal & housing gasket.
Â
Â
Â
Contact our Tech Support Line for further information at...
Intake Manifold Gaskets
LC Engineering offers the best quality gaskets possible for your Toyota engine. Over time, the factory gaskets become brittle and break. Replace a leaky or corroded gasket...
Exhaust Gasket
OEM style gaskets offer the best possible seal for your stock manifold or header. All the LC Engineering headers are designed to use the factory gaskets. Traditional paper exhaust...
Flip Socket
(19mm / 21mm)
For installing wheels and spacers, this is the right tool for the job. 13/16" (21mm) on one end and 3/4" (19mm) on the other. Thin wall design fits better than standard...
Weld-On Attachment Point
(Flat)
Weld-On Attachment Points are machined from Billet 1020 cold rolled steel. They come in two different fitments, one is coped on the bottom so that it can be welded...
Weld-On Attachment Point
(Coped)
Weld-On Attachment Points are machined from Billet 1020 cold rolled steel. They come in two different fitments, one is flat on the bottom so that it can be welded...
Hall Sensor Mount
This bracket is needed if you are installing our Pro Fuel Injection Systems on a 22RE engine. This mount will locate the Hall sensor in the right location for both the stock...
OEM Bell Housing to Block Bolt Set
After many years of sitting in your engine compartment, the bell housing bolts might not be in the best shape, especially if you've had the engine or trans out a...
Garrett T3 Exhaust Discharge Flange
(4-Bolt)
Use 2.5" OD tubing in the groove or 3" OD tubing outside the groove. 3" OD is tight near the bolt holes but works fine so you're not limited to a 2.5"...
Aluminized Heat Sheath
(1.25" x 3')
This aluminized sleeving reflects heat from wiring and hoses. Heat Sheath is easily cut to length. For use on cars, street rods, and trucks.
This product...
Micro Activation Switch & Bracket
This micro-switch and bracket enables performance enthusiasts to activate solenoids, fuel pumps, and most anything else. A micro throttle switch can be used as...
NEW LCE Project 85' Sunset T-Shirt
Show your support at the races or while you're out rock crawling with an LC Engineering t-shirt!
Contact our Tech Support Line for further information at...
The Toyota Trekker (1981–1983) is one of the rarest production vehicles Toyota ever sold in the U.S. market. It was built in partnership with Winnebago Industries — Winnebago took short-bed 1st gen Toyota Pickups and converted them into enclosed SUVs with fiberglass camper-style tops. The Trekker was the proof-of-concept that led Toyota to launch the dedicated 4Runner nameplate in 1984 with a factory-built version of the same idea.
Surviving Trekkers carry the 22R 2.4-liter carbureted four-cylinder — the same engine LCE has been building 22R/22RE parts for since 1985. Our 22R catalog applies directly to Trekker engine work: long blocks, rebuild kits, Weber carburetor conversions, header kits, and OEM-spec replacement components. For body, suspension, and the Winnebago-specific fiberglass components, our technical team can help source or fabricate parts that are no longer available through standard channels.
Browse Trekker parts above, or jump to related content: