Vintage restoration and OEM-replacement parts for the Toyota Trekker — the rare 22R-powered Winnebago/Toyota collaboration that predated the 4Runner nameplate. Engine components, body, suspension, and the hard-to-find pieces that keep these original Trekkers alive.
Magnetic Drain Plug
(w/ Aluminum Washer)
Magnetic Drain Plugs are a great way of keeping metal from building up in the oil. Low profile design uses recessed 10mm Allen socket. Your choice of...
Shackle Bolt
(Greasable)
LC Engineering carries all the parts you need to change or rebuild your own shackles. Bolts feature threaded zerk fittings that won't fall out when you're greasing them.
...
Transfer Case Dust Flange
Dust shield for use with triple drilled output flange. Keeps rocks and other trail debris from damaging seals behind the output flange on your transfer case.
This...
1/4" Pipe to #6 JIC
If you have an IFS steering box and want to tap your own box, this is the fitting you need to do it. This fitting has a male 1/4" pipe fitting on one end and male #6 JIC fitting...
90 Degree Elbow JIC
Need some basic parts for your hydraulic ram steering? With hydraulic hose, high quality crimped connections and JIC 6 ends, these steering components will last.
Optional...
Light Bar Tabs
(Weld-On)
Weld-On Light Tabs are CNC formed from 1/8" thick 1010 steel, coped for 1 1/2" or 1 3/4" O.D. tubing, and have a 1/2" sized bolt hole. These tabs also make great generic...
Inner Axle Seal
When you swap out a Birfield joint it's a good idea to change the inner axle seal at the same time to keep the knuckles clean of weeping oil. This is a great part to keep in your...
Power Steering Reservoir Bracket
This Rock Assault Reservoir Bracket bolts right to the back of our Rock Assault Reservoir and allows you to either weld the other side of the bracket to your cage...
Reservoir Filter Bracket
Our Rock Assault Reservoir Filter Bracket bolts right to the back of our Rock Assault Reservoir Filter Kit (into the pre-tapped holes) and allows you to either weld the...
Air Temp Plate
(Adapts Cold Start Injector to Air Temp Sensor)
Custom made plate to install an air temperature sensor where the cold start injector normally sits.
Contact our Tech Support...
Shackle Spacer For Extra Flex Springs
(Front / Rear)
LC Engineering carries all the parts you need to change or rebuild your own shackles. Bolts feature threaded zerk fittings that won't fall out...
Round Collector Exhaust Gasket Set
This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. In the stock application, two will be required, this is a...
The Toyota Trekker (1981–1983) is one of the rarest production vehicles Toyota ever sold in the U.S. market. It was built in partnership with Winnebago Industries — Winnebago took short-bed 1st gen Toyota Pickups and converted them into enclosed SUVs with fiberglass camper-style tops. The Trekker was the proof-of-concept that led Toyota to launch the dedicated 4Runner nameplate in 1984 with a factory-built version of the same idea.
Surviving Trekkers carry the 22R 2.4-liter carbureted four-cylinder — the same engine LCE has been building 22R/22RE parts for since 1985. Our 22R catalog applies directly to Trekker engine work: long blocks, rebuild kits, Weber carburetor conversions, header kits, and OEM-spec replacement components. For body, suspension, and the Winnebago-specific fiberglass components, our technical team can help source or fabricate parts that are no longer available through standard channels.
Browse Trekker parts above, or jump to related content: