Rock Assault Steering Stops A good set of steering stops is critical so that your steering does not over travel and damage other steering or axle components. Our Rock Assault steering stops are machined from solid billet so you will never have to worry...

Hydro Assist Bracket (OEM Axle Housing / Rock Assault Axle Housing / Tie Rod) Our mounting brackets have a 3/4" or 5/8" bolt hole. The Hydro Assist Brackets are designed to fit a OEM Toyota solid axle front housing, Rock Assault Axle Housings and 1.25"...

Steering Box Fitting (High Pressure) This special fitting is used to connect the high pressure steering hose to the steering box. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further...

Power Steering Pump Pulley (V-Belt) This pulley is designed to fit our standard or full hydraulic power steering pumps. NOTE: Not designed for the stock pump. This product should not be used in a manner that violates Federal EPA Laws. Contact...

Power Steering Reservoir When installing a high flow pump such as the one listed above, it is important to use a larger reservoir to provide enough fluid when the system needs it. The stock reservoir is fine for the stock pump but is not adequate for...

Power Steering Reservoir Bracket This Rock Assault Reservoir Bracket bolts right to the back of our Rock Assault Reservoir and allows you to either weld the other side of the bracket to your cage (coped for 1 1/2" tubing) or simply butt weld it to a...

Reservoir Filter Bracket Our Rock Assault Reservoir Filter Bracket bolts right to the back of our Rock Assault Reservoir Filter Kit (into the pre-tapped holes) and allows you to either weld the other side of the bracket to your cage (coped for 1 1/2"...

Steering Rod Bungs (Weld In) Finally a weld in bung with the thread pitch of an FJ80 Tie Rod Ends, which is the most commonly used Tie Rod Ends in Toyota hi-steer kits. Once welded into your tie rod or drag link, this bung will allow you to make a...

Steering Pump Kit Hoses This kit contains one high pressure and three low pressure power steering lines. These lines are used to connect the pump, steering box and cooler together. The two hoses that go from the steering ram to the steering box are not...

IFS Steering Box Fitting (Low Pressure) This is a Trail Gear low pressure IFS steering box fitting. This product should not be used in a manner that violates Federal EPA Laws. Contact our Tech Support Line for further information at 928-575-2174...

Orbital Mounting Kit Finally an easy way to mount your orbital without all the measuring and fabrication work. This kit is so simple that anyone with basic welding skills can have it fully installed in under an hour. The (3) plates that make up the kit...

Ram Mounting Kit (Double Ended) This kit will take almost all the fabrication work out of mounting your Rock Assault Double Ended Ram and Clevis Kit to almost any axle housing. The main support tube is pre-bent and can be trimmed to size and coped on...