Weld-On Oxygen Sensor Flange (2-Bolt Flange Style) This flange is made from 3/8" mild steel, then tapped for M8 x 1.25 studs weld on. For the 2 bolt style O2 sensor. NOT for thread-in O2 sensors. Contact our Tech Support Line for further...

Street Header Gasket Set LC Engineering also offers gaskets for your Toyota V-6 motor. Just like with our 22R/RE headers, we prefer to use the factory style stainless steel exhaust gaskets. Toyota got it right when they used MLS (Multi-Layer Steel)...

Air Injection Block Plate Kit This plate kit will block off the holes on top of the exhaust manifold or header. Kit Includes: (2) Stainless Steel plates (2) Gaskets NOTE: Not for use on smog checked vehicles, fits LC Headers or header flanges...

Round Collector Exhaust Gasket (2" OD 1.590" ID) This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. Stock applications will require (2). Alternate exhaust gasket sizes: 2.620" OD 1.950" ID, see...

Heat Riser Tubing (1.5" x 36") This heat riser tubing is just what you need if you need to keep the choke plate on your carbureted engine hooked to the exhaust for emissions purposes. This tubing goes from the heat shield on the exhaust manifold to the...

Heat Riser Kit (Attaches Heat Riser To Air Cleaner) This kit is used to connect a heat riser tube to the stock air cleaner assembly. This kit can be used on any header with 1.5" primary tubes. Kit Includes: (3) Hose clamps (1) 1.5″ Standoff (1)...

Oxygen Sensor Adapter (2-Bolt Style To Thread In Style) This kit will adapt a thread in style O2 sensor (18mm) to the Toyota two-bolt style. Includes gasket plate to adapt and two studs and nuts. Contact our Tech Support Line for further...

Exhaust Gasket Almost the same as the OEM 1985 to 1995 22R or RE. The turbo exhaust manifolds use a different stud pattern. NOTE: This will only work w/ the stock style bottom mount turbo manifolds. If you have our top mount turbo manifold, you will...

Round Collector Exhaust Gasket Set This Exhaust gasket is used on the stock exhaust manifold where it connects to the two exhaust pipes. In the stock application, two will be required, this is a kit and will include (2) gaskets. Alternate exhaust...

Exhaust Manifold Stud and Nut When installing new aftermarket headers, new hardware should be used. An even clamping force is required to keep the header tight against the head in order to seal the exhaust gasket properly. The studs on your truck may...

Air Injection Tube Block-off Plate Kit (Trail Gear) Trail-Gear has come up with this very clean way to totally eliminate your stock air injection tube. This kit contains 2 plates that will allow you to install our headers without the air injection tube...

Header Stud Set Replacing your Turbo manifold? It is a good idea to replace your studs too! LC Engineering offers nothing but the best quality components around. The factory exhaust manifold studs have a shoulder in the center that can interfere with...