EGR Block Plate Kit
This EGR block plate kit contains all plates needed to eliminate the EGR systems on 22RE/RET fuel injected engines. This kit will include the three bolt plate that bolts on the cylinder head behind the intake manifold and the two bolt plate that bolts to the intake manifold. Bolts and washers are also included in this kit. The cylinder head plate uses the intake manifold gasket, and the intake plate gasket only comes in gasket kits. If you do not have these gaskets, we recommend using a thin layer of Ultra Grey silicone sealant. If your vehicle is equipped with an EGR Temp Sensor, then either a 10K@ 1/4 watt or 5.6K 1/4 watt resistor can be used to keep the CEL Code from coming on. No way to tell which one you need until you try one..
NOTE: For carbed applications, see Part #: 1016038.
This product should not be used in a manner that violates Federal EPA Laws.
Contact our Tech Support Line for further information at 928-855-6341.
Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!
Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.